mtd: rawnand: fsl_elbc: Fix detection when nand_scan_ident() has not selected ecc...

ecc.mode is set to 0 (aliased to NAND_ECC_NONE) either when function
nand_scan_ident() has not selected ecc.mode or when it selected it to none
ecc mode.

Distinguish between these two states by checking of node property
"nand-ecc-mode" which function nand_scan_ident() uses for filling ecc.mode.

This change fixes usage of none ecc mode if it is specified in DTS file.

Fixes: c9ea9019c5aa ("mtd: rawnand: fsl_elbc: Use ECC configuration from device tree")
Signed-off-by: Pali Rohár <pali@kernel.org>

diff --git a/drivers/mtd/nand/raw/fsl_elbc_nand.c b/drivers/mtd/nand/raw/fsl_elbc_nand.c
index b0e3eb607ed41482fc1b77625945324a08b68b12..48a3687f27282420193037cef6446867d5ee36b0 100644 (file)
--- a/drivers/mtd/nand/raw/fsl_elbc_nand.c
+++ b/drivers/mtd/nand/raw/fsl_elbc_nand.c
@@ -745,7 +745,11 @@ static int fsl_elbc_chip_init(int devnum, u8 *addr, struct udevice *dev)
                return ret;
 
        /* If nand_scan_ident() has not selected ecc.mode, do it now */
-       if (nand->ecc.mode == NAND_ECC_NONE) {
+       if (nand->ecc.mode == 0
+#if CONFIG_IS_ENABLED(OF_CONTROL)
+           && !ofnode_read_string(nand->flash_node, "nand-ecc-mode")
+#endif
+          ) {
                /* If CS Base Register selects full hardware ECC then use it */
                if ((br & BR_DECC) == BR_DECC_CHK_GEN) {
                        nand->ecc.mode = NAND_ECC_HW;