From: Sumit Garg Date: Mon, 19 Feb 2024 08:41:44 +0000 (+0530) Subject: qcom_defconfig: Enable ethernet and I2C support X-Git-Url: http://git.dujemihanovic.xyz/html/index.html?a=commitdiff_plain;h=b621dcd16246d5271ae000701c50b2deaac3feab;p=u-boot.git qcom_defconfig: Enable ethernet and I2C support QCS404 supports Synopsys Designware Ethernet QOS IP and we already have the corresponding glue layer present upstream as: drivers/net/dwc_eth_qos_qcom.c. So enable corresponding support. Along with that it is possible for Qualcomm platforms to retrieve MAC address from I2C eeprom present on board. So enable corresponding support as well. Signed-off-by: Sumit Garg Signed-off-by: Caleb Connolly --- diff --git a/configs/qcom_defconfig b/configs/qcom_defconfig index 222db6448a..cbc612b44b 100644 --- a/configs/qcom_defconfig +++ b/configs/qcom_defconfig @@ -26,7 +26,6 @@ CONFIG_CMD_USB=y CONFIG_CMD_CAT=y CONFIG_CMD_BMP=y CONFIG_CMD_LOG=y -# CONFIG_NET is not set CONFIG_BUTTON_QCOM_PMIC=y CONFIG_CLK=y CONFIG_CLK_QCOM_QCS404=y @@ -65,3 +64,26 @@ CONFIG_VIDEO_SIMPLE=y CONFIG_HEXDUMP=y # CONFIG_GENERATE_SMBIOS_TABLE is not set CONFIG_LMB_MAX_REGIONS=64 +CONFIG_CMD_DHCP=y +CONFIG_CMD_EEPROM=y +CONFIG_CMD_I2C=y +CONFIG_CMD_PING=y +CONFIG_DM_ETH=y +CONFIG_DM_ETH_PHY=y +CONFIG_DM_MDIO=y +CONFIG_DWC_ETH_QOS=y +CONFIG_DWC_ETH_QOS_QCOM=y +CONFIG_RGMII=y +CONFIG_PHY_MICREL=y +CONFIG_PHY_MICREL_KSZ90X1=y +CONFIG_MISC=y +CONFIG_NVMEM=y +CONFIG_DM_I2C=y +CONFIG_I2C_SUPPORT=y +CONFIG_I2C_MUX=y +CONFIG_I2C_EEPROM=y +CONFIG_SYS_I2C=y +CONFIG_SYS_I2C_QUP=y +CONFIG_SYS_I2C_EEPROM_BUS=2 +CONFIG_SYS_I2C_EEPROM_ADDR_LEN=2 +CONFIG_SYS_EEPROM_PAGE_WRITE_BITS=5