From: Manorit Chawdhry Date: Fri, 29 Dec 2023 10:46:33 +0000 (+0530) Subject: docs: board: ti: k3: Add secure booting documentation X-Git-Url: http://git.dujemihanovic.xyz/html/index.html?a=commitdiff_plain;h=7ff09d484e5ca11934bec8023f10062a336e61b5;p=u-boot.git docs: board: ti: k3: Add secure booting documentation This commit adds a general flow to explain the usage of firewalls and the chain of trust in K3 devices. Signed-off-by: Manorit Chawdhry --- diff --git a/doc/board/ti/k3.rst b/doc/board/ti/k3.rst index 1064c21b5a..7dfe39c5fa 100644 --- a/doc/board/ti/k3.rst +++ b/doc/board/ti/k3.rst @@ -104,6 +104,49 @@ firmware can be loaded on the now free core in the wakeup domain. For more information on the bootup process of your SoC, consult the device specific boot flow documentation. +Secure Boot +----------- + +K3 HS-SE (High Security - Security Enforced) devices enforce an +authenticated boot flow for secure boot. HS-FS (High Security - Field +Securable) is the state of a K3 device before it has been eFused with +customer security keys. In the HS-FS state the authentication still can +function as in HS-SE but as there are no customer keys to verify the +signatures against the authentication will pass for certificates signed +with any key. + +Chain of trust +^^^^^^^^^^^^^^ + +1) Public ROM loads the tiboot3.bin (R5 SPL, TIFS) +2) R5 SPL loads tispl.bin (ATF, OP-TEE, DM, SPL) +3) SPL loads u-boot.img (U-Boot) +4) U-Boot loads fitImage (Linux and DTBs) + +Steps 1-3 are all authenticated by either the Secure ROM or TIFS as the +authenticating entity and step 4 uses U-boot standard mechanism for +authenticating. + +All the authentication that are done for ROM/TIFS are done through x509 +certificates that are signed. + +Firewalls +^^^^^^^^^ + +1) Secure ROM comes up and sets up firewalls that are needed by itself +2) TIFS will setup it's own firewalls to protect core system resources +3) R5 SPL will remove any firewalls that are leftover from the Secure ROM stage + that are no longer required. +4) Each stage beyond this: such as tispl.bin containing TFA/OPTEE uses OIDs to + set up firewalls to protect themselves (enforced by TIFS) +5) TFA/OP-TEE can configure other firewalls at runtime if required as they + are already authenticated and firewalled off from illegal access. +6) All later stages can setup or remove firewalls that have not been already + configured by previous stages, such as those created by TIFS, TFA, and OP-TEE. + +Futhur, firewalls have a lockdown bit in hardware that enforces the setting +(and cannot be over-ridden) until the full system is reset. + Software Sources ----------------