Remove a stray semicolon in MCR3000 board environment.
Signed-off-by: Jean-Michel CASAUBON <jean-michel.casaubon@csgroup.eu>
Reviewed-by: DUBOIS Hugo <hugo.dubois.ext@csgroup.eu>
Signed-off-by: Christophe Leroy <christophe.leroy@csgroup.eu>
console_args=console=ttyCPM0,115200N8
loadkernel=ubi part nand0;ubifsmount ubi0;ubifsload ${loadaddr} /boot/${filename};ubifsumount; ubi detach
bootcmd=run flashboot
-flashboot=setenv bootargs ${console_args} ip=${ipaddr}:${serverip}:${gatewayip}:${netmask}:mcr3k:eth0:off;${ofl_args}; run loadkernel; bootm ${loadaddr}
+flashboot=setenv bootargs ${console_args} ip=${ipaddr}:${serverip}:${gatewayip}:${netmask}:mcr3k:eth0:off ${ofl_args}; run loadkernel; bootm ${loadaddr}
tftpboot=setenv bootargs ${console_args} ip=${ipaddr}:${serverip}:${gatewayip}:${netmask}:mcr3k:eth0:off ${ofl_args}; tftp ${loadaddr} ${filename}; bootm ${loadaddr}
dhcpboot=dhcp ${loadaddr} ${filename};setenv bootargs ${console_args} ${dhcp_ip} ${ofl_args}; bootm ${loadaddr}
update=echo 'Updating ubi image'; if tftp 0x2000 $ubifile; then nand erase.chip; nand write 0x2000 0x00 $filesize; fi