--- /dev/null
+// SPDX-License-Identifier: GPL-2.0+
+/*
+ * Copyright (C) 2014 Beniamino Galvani <b.galvani@gmail.com>
+ * Copyright (C) 2018 BayLibre, SAS
+ * Author: Neil Armstrong <narmstrong@baylibre.com>
+ *
+ * Amlogic Meson SPI Flash Controller driver
+ */
+
+#include <common.h>
+#include <spi.h>
+#include <clk.h>
+#include <dm.h>
+#include <regmap.h>
+#include <errno.h>
+#include <asm/io.h>
+#include <linux/bitfield.h>
+
+/* register map */
+#define REG_CMD 0x00
+#define REG_ADDR 0x04
+#define REG_CTRL 0x08
+#define REG_CTRL1 0x0c
+#define REG_STATUS 0x10
+#define REG_CTRL2 0x14
+#define REG_CLOCK 0x18
+#define REG_USER 0x1c
+#define REG_USER1 0x20
+#define REG_USER2 0x24
+#define REG_USER3 0x28
+#define REG_USER4 0x2c
+#define REG_SLAVE 0x30
+#define REG_SLAVE1 0x34
+#define REG_SLAVE2 0x38
+#define REG_SLAVE3 0x3c
+#define REG_C0 0x40
+#define REG_B8 0x60
+#define REG_MAX 0x7c
+
+/* register fields */
+#define CMD_USER BIT(18)
+#define CTRL_ENABLE_AHB BIT(17)
+#define CLOCK_SOURCE BIT(31)
+#define CLOCK_DIV_SHIFT 12
+#define CLOCK_DIV_MASK (0x3f << CLOCK_DIV_SHIFT)
+#define CLOCK_CNT_HIGH_SHIFT 6
+#define CLOCK_CNT_HIGH_MASK (0x3f << CLOCK_CNT_HIGH_SHIFT)
+#define CLOCK_CNT_LOW_SHIFT 0
+#define CLOCK_CNT_LOW_MASK (0x3f << CLOCK_CNT_LOW_SHIFT)
+#define USER_DIN_EN_MS BIT(0)
+#define USER_CMP_MODE BIT(2)
+#define USER_CLK_NOT_INV BIT(7)
+#define USER_UC_DOUT_SEL BIT(27)
+#define USER_UC_DIN_SEL BIT(28)
+#define USER_UC_MASK ((BIT(5) - 1) << 27)
+#define USER1_BN_UC_DOUT_SHIFT 17
+#define USER1_BN_UC_DOUT_MASK (0xff << 16)
+#define USER1_BN_UC_DIN_SHIFT 8
+#define USER1_BN_UC_DIN_MASK (0xff << 8)
+#define USER4_CS_POL_HIGH BIT(23)
+#define USER4_IDLE_CLK_HIGH BIT(29)
+#define USER4_CS_ACT BIT(30)
+#define SLAVE_TRST_DONE BIT(4)
+#define SLAVE_OP_MODE BIT(30)
+#define SLAVE_SW_RST BIT(31)
+
+#define SPIFC_BUFFER_SIZE 64
+
+struct meson_spifc_priv {
+ struct regmap *regmap;
+ struct clk clk;
+};
+
+/**
+ * meson_spifc_drain_buffer() - copy data from device buffer to memory
+ * @spifc: the Meson SPI device
+ * @buf: the destination buffer
+ * @len: number of bytes to copy
+ */
+static void meson_spifc_drain_buffer(struct meson_spifc_priv *spifc,
+ u8 *buf, int len)
+{
+ u32 data;
+ int i = 0;
+
+ while (i < len) {
+ regmap_read(spifc->regmap, REG_C0 + i, &data);
+
+ if (len - i >= 4) {
+ *((u32 *)buf) = data;
+ buf += 4;
+ } else {
+ memcpy(buf, &data, len - i);
+ break;
+ }
+ i += 4;
+ }
+}
+
+/**
+ * meson_spifc_fill_buffer() - copy data from memory to device buffer
+ * @spifc: the Meson SPI device
+ * @buf: the source buffer
+ * @len: number of bytes to copy
+ */
+static void meson_spifc_fill_buffer(struct meson_spifc_priv *spifc,
+ const u8 *buf, int len)
+{
+ u32 data = 0;
+ int i = 0;
+
+ while (i < len) {
+ if (len - i >= 4)
+ data = *(u32 *)buf;
+ else
+ memcpy(&data, buf, len - i);
+
+ regmap_write(spifc->regmap, REG_C0 + i, data);
+
+ buf += 4;
+ i += 4;
+ }
+}
+
+/**
+ * meson_spifc_txrx() - transfer a chunk of data
+ * @spifc: the Meson SPI device
+ * @dout: data buffer for TX
+ * @din: data buffer for RX
+ * @offset: offset of the data to transfer
+ * @len: length of the data to transfer
+ * @last_xfer: whether this is the last transfer of the message
+ * @last_chunk: whether this is the last chunk of the transfer
+ * Return: 0 on success, a negative value on error
+ */
+static int meson_spifc_txrx(struct meson_spifc_priv *spifc,
+ const u8 *dout, u8 *din, int offset,
+ int len, bool last_xfer, bool last_chunk)
+{
+ bool keep_cs = true;
+ u32 data;
+ int ret;
+
+ if (dout)
+ meson_spifc_fill_buffer(spifc, dout + offset, len);
+
+ /* enable DOUT stage */
+ regmap_update_bits(spifc->regmap, REG_USER, USER_UC_MASK,
+ USER_UC_DOUT_SEL);
+ regmap_write(spifc->regmap, REG_USER1,
+ (8 * len - 1) << USER1_BN_UC_DOUT_SHIFT);
+
+ /* enable data input during DOUT */
+ regmap_update_bits(spifc->regmap, REG_USER, USER_DIN_EN_MS,
+ USER_DIN_EN_MS);
+
+ if (last_chunk && last_xfer)
+ keep_cs = false;
+
+ regmap_update_bits(spifc->regmap, REG_USER4, USER4_CS_ACT,
+ keep_cs ? USER4_CS_ACT : 0);
+
+ /* clear transition done bit */
+ regmap_update_bits(spifc->regmap, REG_SLAVE, SLAVE_TRST_DONE, 0);
+ /* start transfer */
+ regmap_update_bits(spifc->regmap, REG_CMD, CMD_USER, CMD_USER);
+
+ /* wait for the current operation to terminate */
+ ret = regmap_read_poll_timeout(spifc->regmap, REG_SLAVE, data,
+ (data & SLAVE_TRST_DONE),
+ 0, 5 * CONFIG_SYS_HZ);
+
+ if (!ret && din)
+ meson_spifc_drain_buffer(spifc, din + offset, len);
+
+ return ret;
+}
+
+/**
+ * meson_spifc_xfer() - perform a single transfer
+ * @dev: the SPI controller device
+ * @bitlen: length of the transfer
+ * @dout: data buffer for TX
+ * @din: data buffer for RX
+ * @flags: transfer flags
+ * Return: 0 on success, a negative value on error
+ */
+static int meson_spifc_xfer(struct udevice *slave, unsigned int bitlen,
+ const void *dout, void *din, unsigned long flags)
+{
+ struct meson_spifc_priv *spifc = dev_get_priv(slave->parent);
+ int blen = bitlen / 8;
+ int len, done = 0, ret = 0;
+
+ if (bitlen % 8)
+ return -EINVAL;
+
+ debug("xfer len %d (%d) dout %p din %p\n", bitlen, blen, dout, din);
+
+ regmap_update_bits(spifc->regmap, REG_CTRL, CTRL_ENABLE_AHB, 0);
+
+ while (done < blen && !ret) {
+ len = min_t(int, blen - done, SPIFC_BUFFER_SIZE);
+ ret = meson_spifc_txrx(spifc, dout, din, done, len,
+ flags & SPI_XFER_END,
+ done + len >= blen);
+ done += len;
+ }
+
+ regmap_update_bits(spifc->regmap, REG_CTRL, CTRL_ENABLE_AHB,
+ CTRL_ENABLE_AHB);
+
+ return ret;
+}
+
+/**
+ * meson_spifc_set_speed() - program the clock divider
+ * @dev: the SPI controller device
+ * @speed: desired speed in Hz
+ */
+static int meson_spifc_set_speed(struct udevice *dev, uint speed)
+{
+ struct meson_spifc_priv *spifc = dev_get_priv(dev);
+ unsigned long parent, value;
+ int n;
+
+ parent = clk_get_rate(&spifc->clk);
+ n = max_t(int, parent / speed - 1, 1);
+
+ debug("parent %lu, speed %u, n %d\n", parent, speed, n);
+
+ value = (n << CLOCK_DIV_SHIFT) & CLOCK_DIV_MASK;
+ value |= (n << CLOCK_CNT_LOW_SHIFT) & CLOCK_CNT_LOW_MASK;
+ value |= (((n + 1) / 2 - 1) << CLOCK_CNT_HIGH_SHIFT) &
+ CLOCK_CNT_HIGH_MASK;
+
+ regmap_write(spifc->regmap, REG_CLOCK, value);
+
+ return 0;
+}
+
+/**
+ * meson_spifc_set_mode() - setups the SPI bus mode
+ * @dev: the SPI controller device
+ * @mode: desired mode bitfield
+ * Return: 0 on success, -ENODEV on error
+ */
+static int meson_spifc_set_mode(struct udevice *dev, uint mode)
+{
+ struct meson_spifc_priv *spifc = dev_get_priv(dev);
+
+ if (mode & (SPI_CPHA | SPI_RX_QUAD | SPI_RX_DUAL |
+ SPI_TX_QUAD | SPI_TX_DUAL))
+ return -ENODEV;
+
+ regmap_update_bits(spifc->regmap, REG_USER, USER_CLK_NOT_INV,
+ mode & SPI_CPOL ? USER_CLK_NOT_INV : 0);
+
+ regmap_update_bits(spifc->regmap, REG_USER4, USER4_CS_POL_HIGH,
+ mode & SPI_CS_HIGH ? USER4_CS_POL_HIGH : 0);
+
+ return 0;
+}
+
+/**
+ * meson_spifc_hw_init() - reset and initialize the SPI controller
+ * @spifc: the Meson SPI device
+ */
+static void meson_spifc_hw_init(struct meson_spifc_priv *spifc)
+{
+ /* reset device */
+ regmap_update_bits(spifc->regmap, REG_SLAVE, SLAVE_SW_RST,
+ SLAVE_SW_RST);
+ /* disable compatible mode */
+ regmap_update_bits(spifc->regmap, REG_USER, USER_CMP_MODE, 0);
+ /* set master mode */
+ regmap_update_bits(spifc->regmap, REG_SLAVE, SLAVE_OP_MODE, 0);
+}
+
+static const struct dm_spi_ops meson_spifc_ops = {
+ .xfer = meson_spifc_xfer,
+ .set_speed = meson_spifc_set_speed,
+ .set_mode = meson_spifc_set_mode,
+};
+
+static int meson_spifc_probe(struct udevice *dev)
+{
+ struct meson_spifc_priv *priv = dev_get_priv(dev);
+ int ret;
+
+ ret = regmap_init_mem(dev_ofnode(dev), &priv->regmap);
+ if (ret)
+ return ret;
+
+ ret = clk_get_by_index(dev, 0, &priv->clk);
+ if (ret)
+ return ret;
+
+ ret = clk_enable(&priv->clk);
+ if (ret)
+ return ret;
+
+ meson_spifc_hw_init(priv);
+
+ return 0;
+}
+
+static const struct udevice_id meson_spifc_ids[] = {
+ { .compatible = "amlogic,meson-gxbb-spifc", },
+ { }
+};
+
+U_BOOT_DRIVER(meson_spifc) = {
+ .name = "meson_spifc",
+ .id = UCLASS_SPI,
+ .of_match = meson_spifc_ids,
+ .ops = &meson_spifc_ops,
+ .probe = meson_spifc_probe,
+ .priv_auto_alloc_size = sizeof(struct meson_spifc_priv),
+};
projects / u-boot.git / commitdiff