i2c: designware_i2c: check is high speed possible support

To read IC_COMP_PARAM_1[3:2] to check is high speed possible,
and fall back to fast mode if not.

Signed-off-by: Jun Chen <ptchentw@gmail.com>
Signed-off-by: Jun Chen <jun.chen@vatics.com>

diff --git a/drivers/i2c/designware_i2c.c b/drivers/i2c/designware_i2c.c
index 9186fcb7dc9bdc67f9d874940e26d8da7c8e16ef..f4fbf3ba9f5017b67d34800ef92fa75827919535 100644 (file)
--- a/drivers/i2c/designware_i2c.c
+++ b/drivers/i2c/designware_i2c.c
@@ -203,9 +203,12 @@ static int calc_bus_speed(struct dw_i2c *priv, int speed, ulong bus_clk,
        const struct dw_scl_sda_cfg *scl_sda_cfg = NULL;
        struct i2c_regs *regs = priv->regs;
        enum i2c_speed_mode i2c_spd;
+       u32 comp_param1;
        int spk_cnt;
        int ret;
 
+       comp_param1 = readl(&regs->comp_param1);
+
        if (priv)
                scl_sda_cfg = priv->scl_sda_cfg;
        /* Allow high speed if there is no config, or the config allows it */
@@ -219,6 +222,13 @@ static int calc_bus_speed(struct dw_i2c *priv, int speed, ulong bus_clk,
        else
                i2c_spd = IC_SPEED_MODE_STANDARD;
 
+       /* Check is high speed possible and fall back to fast mode if not */
+       if (i2c_spd == IC_SPEED_MODE_HIGH) {
+               if ((comp_param1 & DW_IC_COMP_PARAM_1_SPEED_MODE_MASK)
+                               != DW_IC_COMP_PARAM_1_SPEED_MODE_HIGH)
+                       i2c_spd = IC_SPEED_MODE_FAST;
+       }
+
        /* Get the proper spike-suppression count based on target speed */
        if (!priv || !priv->has_spk_cnt)
                spk_cnt = 0;

diff --git a/drivers/i2c/designware_i2c.h b/drivers/i2c/designware_i2c.h
index 61a882cb650dd7a7ce2cdd91e4e89683a753ccfe..23f311b61ca2c044b9b1a8bb6a809876a1971807 100644 (file)
--- a/drivers/i2c/designware_i2c.h
+++ b/drivers/i2c/designware_i2c.h
@@ -138,6 +138,9 @@ struct i2c_regs {
 #define IC_STATUS_TFNF         0x0002
 #define IC_STATUS_ACT          0x0001
 
+#define DW_IC_COMP_PARAM_1_SPEED_MODE_HIGH      (BIT(2) | BIT(3))
+#define DW_IC_COMP_PARAM_1_SPEED_MODE_MASK      (BIT(2) | BIT(3))
+
 /**
  * struct dw_scl_sda_cfg - I2C timing configuration
  *