From: Baruch Siach Date: Fri, 19 Feb 2021 16:11:17 +0000 (+0100) Subject: ddr: marvell: a38x: allow board specific ODT configuration X-Git-Url: http://git.dujemihanovic.xyz/html/%7B%7B%20%28.OutputFormats.Get?a=commitdiff_plain;h=369e532691e0df4bce5ea8d0963ec3dc061d15a6;p=u-boot.git ddr: marvell: a38x: allow board specific ODT configuration commit 2d3b9437cf38c06c4330e0de07f29476197f5e04 upstream. The ODT enable heuristic based on active chip-selects is not always correct. Some board might use two chip-selects, but have only one ODT line connected. Allow board specific mv_ddr_topology_map to directly set the ODT configuration register value. Signed-off-by: Baruch Siach Reviewed-by: Moti Buskila Reviewed-by: Nadav Haklai Reviewed-by: Kostya Porotchkin Signed-off-by: Marek BehĂșn Tested-by: Chris Packham --- diff --git a/drivers/ddr/marvell/a38x/ddr3_init.c b/drivers/ddr/marvell/a38x/ddr3_init.c index a971cc155a..7488770268 100644 --- a/drivers/ddr/marvell/a38x/ddr3_init.c +++ b/drivers/ddr/marvell/a38x/ddr3_init.c @@ -104,6 +104,7 @@ int ddr3_init(void) static int mv_ddr_training_params_set(u8 dev_num) { struct tune_train_params params; + struct mv_ddr_topology_map *tm = mv_ddr_topology_map_get(); int status; u32 cs_num; int ck_delay; @@ -136,6 +137,10 @@ static int mv_ddr_training_params_set(u8 dev_num) if (ck_delay > 0) params.ck_delay = ck_delay; + /* Use platform specific override ODT value */ + if (tm->odt_config) + params.g_odt_config = tm->odt_config; + status = ddr3_tip_tune_training_params(dev_num, ¶ms); if (MV_OK != status) { printf("%s Training Sequence - FAILED\n", ddr_type); diff --git a/drivers/ddr/marvell/a38x/ddr_topology_def.h b/drivers/ddr/marvell/a38x/ddr_topology_def.h index 342c2cf451..3991fec272 100644 --- a/drivers/ddr/marvell/a38x/ddr_topology_def.h +++ b/drivers/ddr/marvell/a38x/ddr_topology_def.h @@ -125,6 +125,9 @@ struct mv_ddr_topology_map { /* electrical parameters */ unsigned int electrical_data[MV_DDR_EDATA_LAST]; + /* ODT configuration */ + u32 odt_config; + /* Clock enable mask */ u32 clk_enable;