]> git.dujemihanovic.xyz Git - u-boot.git/shortlog
u-boot.git
2018-03-23 Vipul Kumararm64: zynqmp: Changed scratch address used by the...
2018-03-23 Michal Simekarm: zynq: Enable cadence driver on zc706
2018-03-23 Michal Simekarm: zynq: Wire watchdog internals
2018-03-23 Shreenidhi... watchdog: Add Cadence watchdog driver
2018-03-23 Michal Simekclk: zynq: Show watchdog clock rate properly
2018-03-23 Michal Simekarm64: zynqmp: Enable newer pmufw versions
2018-03-23 Siva Durga... net: zynq_gem: Dont run any phy detection logic for...
2018-03-23 Nitin Jainarm64: zynqmp: Add support to load an app at EL1
2018-03-23 Siva Durga... arm: zynq: Enable debug uart on Zedboard
2018-03-23 Michal Simekarm64: zynqmp: Enable ethernet driver for zc1751-dc5
2018-03-23 Michal Simekfpga: Simplify error path in fpga_add
2018-03-23 Michal Simekxilinx: Sync defconfigs with latest Kconfig updates
2018-03-23 Michal Simekarm64: zynqmp: Convert board to use zynqmp-clk driver
2018-03-22 Tom RiniMerge git://git.denx.de/u-boot-net
2018-03-22 Lokesh Vutlaconfigs: omapl138: Enable DM and DT
2018-03-22 Lokesh VutlaARM: dts: da850-lcdk: Sync from Linux 4.16
2018-03-22 Lokesh Vutladavinci: Enable DDR_INIT for DA8XX
2018-03-22 Faiz Abbasconfigs: am335x_evm: Increase SPL_SYS_MALLOC_F_LEN...
2018-03-22 Faiz Abbasgpio: omap_gpio: Add DM_FLAG_PRE_RELOC flag
2018-03-22 Luca Ceresoliscripts/check-config.sh: fix "command not found" error...
2018-03-22 David Lechnerdavinci: omapl138_lcdk: fix PLL0 frequency
2018-03-22 Liam Beguintest/py: add spi_flash tests
2018-03-22 Tuomas Tynkkynennet: Drop CONFIG_ENC28J60
2018-03-22 Heinrich Schuchardtnet: macb: remove superfluous logical constraint
2018-03-22 Heinrich Schuchardtdrivers: net: cpsw: remove superfluous assignment.
2018-03-22 Alexander Graflan7xxx: Require phylib
2018-03-22 Alexander Grafnet: Only access network devices after init
2018-03-22 Leonid Iziumtsevnet: Fix netretry condition
2018-03-22 Priyanka Jainnet/phy/cortina: Add No firmware upload option
2018-03-22 Priyanka Jainnet/phy/cortina.c: Update get_phy_id implementation
2018-03-22 Calvin Johnsonconfigs: ls1012a: add pfe configuration for LS1012A
2018-03-22 Calvin Johnsonarmv8: layerscape: csu: enable ns access to PFE registers
2018-03-22 Calvin Johnsonarmv8: fsl-lsch2: configure pfe's DDR and HDBUS interfa...
2018-03-22 Calvin Johnsonarmv8: fsl-lsch2: add pfe macros and update ccsr_scfg...
2018-03-22 Calvin Johnsonboard: freescale: ls1012a2g5rdb: enable network support...
2018-03-22 Calvin Johnsonboard: freescale: ls1012ardb: enable network support...
2018-03-22 Calvin Johnsonboard: freescale: ls1012afrdm: enable network support...
2018-03-22 Calvin Johnsonboard: freescale: ls1012aqds: enable network support...
2018-03-22 Calvin Johnsondrivers: net: pfe_eth: LS1012A PFE headers
2018-03-22 Calvin Johnsondrivers: net: pfe_eth: provide pfe commands
2018-03-22 Calvin Johnsondrivers: net: pfe_eth: LS1012A PFE driver introduction
2018-03-22 Prabhakar Kushwahaarmv8: fsl-layerscape: Add support of GPIO structure
2018-03-22 Calvin Johnsondrivers: net: phy: Fix aquantia compilation with DM
2018-03-22 Heinrich Schuchardtnet: mvpp2x: add check after calloc
2018-03-22 kevans@FreeBSD.orgConfigs: Use the newly added PHY_RTL8211E_PINE64_GIGABI...
2018-03-22 kevans@FreeBSD.orgnet: phy: Add PHY_RTL8211E_PINE64_GIGABIT_FIX for realt...
2018-03-22 Liam Beguintest/py: add generic CRC32 function
2018-03-22 Liam Beguintest/py: do not import pytest multiple times
2018-03-22 Liam Beguintest/py: README: add HOSTNAME to PYTHONPATH
2018-03-22 Liam Beguintest/py: README: fix typo
2018-03-22 Liam Beguincmd: sf: fix map_physmem check
2018-03-22 Liam Beguinspi: spi_flash: do not fail silently on bad user input
2018-03-22 Tuomas Tynkkynentools: Make kwboot build if HOST_TOOLS_ALL=y
2018-03-21 Tom RiniMerge git://git.denx.de/u-boot-mips
2018-03-21 Álvaro Fernández... mips: bmips: add ar-5315 usb support
2018-03-21 Álvaro Fernández... mips: bmips: add support for bcm6318 usb
2018-03-21 Álvaro Fernández... phy: add support for bcm6318 usbh phy
2018-03-21 Álvaro Fernández... mips: bmips: add vr-3032u usb support
2018-03-21 Álvaro Fernández... mips: bmips: add support for bcm63268 usb
2018-03-21 Álvaro Fernández... mips: bmips: add dgnd3700v2 usb support
2018-03-21 Álvaro Fernández... mips: bmips: add support for bcm6362 usb
2018-03-21 Álvaro Fernández... mips: bmips: add ar-5387un usb support
2018-03-21 Álvaro Fernández... mips: bmips: add support for bcm6328 usb
2018-03-21 Álvaro Fernández... mips: bmips: add wap-5813n usb support
2018-03-21 Álvaro Fernández... mips: bmips: add support for bcm6368 usb
2018-03-21 Álvaro Fernández... phy: add support for bcm6368 usbh phy
2018-03-21 Álvaro Fernández... mips: bmips: add nb4-ser usb support
2018-03-21 Álvaro Fernández... mips: bmips: add hg556a usb support
2018-03-21 Álvaro Fernández... mips: bmips: add support for bcm6358 usb
2018-03-21 Álvaro Fernández... phy: add support for bcm6358 usbh phy
2018-03-21 Álvaro Fernández... mips: bmips: add ct-5361 usb support
2018-03-21 Álvaro Fernández... mips: bmips: add support for bcm6348 usb
2018-03-21 Álvaro Fernández... phy: add support for bcm6348 usbh phy
2018-03-21 Heinrich Schuchardtmips: micronas/vct: check array bounds before access
2018-03-21 Álvaro Fernández... mips: bmips: select OF_EMBED for all boards
2018-03-21 Álvaro Fernández... MIPS: add BMIPS Netgear DGND3700v2 board
2018-03-21 Álvaro Fernández... MIPS: add support for Broadcom MIPS BCM6362 SoC family
2018-03-21 Álvaro Fernández... dm: cpu: bmips: add BCM6362 support
2018-03-20 Tom RiniMerge git://git.denx.de/u-boot-fsl-qoriq
2018-03-20 Vinitha V PillaiLS2088ARDB: Secure Boot: Fix fall back option failure
2018-03-20 Ashish Kumararmv8: ls1088aqds: Add IFC-NOR as boot source for LS1088
2018-03-20 Ashish Kumararmv8: ls1088a: Add i2c_early_init() func for LS1088AQDS
2018-03-20 Ashish Kumararmv8: ls1088a: Add clock related function in CONFIG_SP...
2018-03-20 Ashish Kumararmv8: ls1088qds: Remove CONFIG_ from local defines...
2018-03-20 Tom RiniMerge git://git.denx.de/u-boot-usb
2018-03-19 Tom RiniMerge git://git.denx.de/u-boot-sunxi
2018-03-19 Bryan O'Donoghuebootm: optee: Add a bootm command for type IH_OS_TEE
2018-03-19 Bryan O'Donoghueimage: Add IH_OS_TEE for TEE chain-load boot
2018-03-19 Bryan O'Donoghueoptee: Add error printout
2018-03-19 Bryan O'Donoghueoptee: Add optee_verify_bootm_image()
2018-03-19 Bryan O'Donoghueoptee: Add optee_image_get_load_addr()
2018-03-19 Bryan O'Donoghueoptee: Add optee_image_get_entry_point()
2018-03-19 Bryan O'Donoghueoptee: Add CONFIG_OPTEE_LOAD_ADDR
2018-03-19 Bryan O'Donoghueoptee: Add CONFIG_OPTEE_TZDRAM_BASE
2018-03-19 Bryan O'Donoghueoptee: Add CONFIG_OPTEE_TZDRAM_SIZE
2018-03-19 Bryan O'Donoghueoptee: Add lib entries for sharing OPTEE code across...
2018-03-19 Stefan RoeseMAINTAINERS: Remove unused ppc4xx entry
2018-03-19 Stefan Roesepci: Remove unused ppc4xx variable from struct pci_cont...
2018-03-19 Stefan Roesenand: Remove unused ppc4xx NAND driver and references
2018-03-19 Patrick Delaunayboard: st: add generic board for STM32MP1 family
next