From: Bhuvanchandra DV Date: Wed, 24 Feb 2016 08:33:24 +0000 (+0530) Subject: colibri-vf: Disable pull-up configuration in GPIO pin mux X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=fc9e8f2817d8024f2c1e0e13c80111a9fa4bbce9;p=u-boot.git colibri-vf: Disable pull-up configuration in GPIO pin mux During very early boot-ROM execution the pinmux configuration isi in Hi-Z state. If pull-up is enabled on GPIO pad's there will be a short period of toggle from high to low on the IO when GPIO is set low during boot. To avoid this glitch, disable pull-up configuration in GPIO pinmux. Signed-off-by: Bhuvanchandra DV --- diff --git a/arch/arm/include/asm/arch-vf610/iomux-vf610.h b/arch/arm/include/asm/arch-vf610/iomux-vf610.h index 0e2bd5366c..a140be05f1 100644 --- a/arch/arm/include/asm/arch-vf610/iomux-vf610.h +++ b/arch/arm/include/asm/arch-vf610/iomux-vf610.h @@ -34,7 +34,7 @@ PAD_CTL_PUS_22K_UP | PAD_CTL_OBE_IBE_ENABLE) #define VF610_GPIO_PAD_CTRL (PAD_CTL_SPEED_MED | PAD_CTL_DSE_50ohm | \ - PAD_CTL_PUS_47K_UP | PAD_CTL_IBE_ENABLE) + PAD_CTL_IBE_ENABLE) #define VF610_DSPI_PAD_CTRL (PAD_CTL_OBE_ENABLE | PAD_CTL_DSE_20ohm | \ PAD_CTL_PUS_100K_UP | PAD_CTL_SPEED_HIGH)