From: Peter Pearse Date: Fri, 1 Feb 2008 16:49:08 +0000 (+0000) Subject: Update board NetStar X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=f4e7cbfcb0fcbc325a2bcfea7e00e3dd37f93846;p=u-boot.git Update board NetStar Signed-off-by: Ladislav Michl --- diff --git a/Makefile b/Makefile index 3b339ad17e..df00abe866 100644 --- a/Makefile +++ b/Makefile @@ -2348,17 +2348,8 @@ mx1ads_config : unconfig mx1fs2_config : unconfig @$(MKCONFIG) $(@:_config=) arm arm920t mx1fs2 NULL imx -netstar_32_config \ netstar_config: unconfig - @mkdir -p $(obj)include - @if [ "$(findstring _32_,$@)" ] ; then \ - $(XECHO) "... 32MB SDRAM" ; \ - echo "#define PHYS_SDRAM_1_SIZE SZ_32M" >>$(obj)include/config.h ; \ - else \ - $(XECHO) "... 64MB SDRAM" ; \ - echo "#define PHYS_SDRAM_1_SIZE SZ_64M" >>$(obj)include/config.h ; \ - fi - @$(MKCONFIG) -a netstar arm arm925t netstar + @$(MKCONFIG) $(@:_config=) arm arm925t netstar omap1510inn_config : unconfig @$(MKCONFIG) $(@:_config=) arm arm925t omap1510inn diff --git a/board/netstar/nand.c b/board/netstar/nand.c index d47e1d8e02..b76d2a3324 100644 --- a/board/netstar/nand.c +++ b/board/netstar/nand.c @@ -45,23 +45,12 @@ static void netstar_nand_hwcontrol(struct mtd_info *mtd, int cmd) this->IO_ADDR_W = (void *) IO_ADDR_W; } -/* - * chip R/B detection - */ -/*** -static int netstar_nand_ready(struct mtd_info *mtd) -{ - return (*(volatile ushort *)GPIO_DATA_INPUT_REG) & 0x02; -} -***/ - int board_nand_init(struct nand_chip *nand) { nand->options = NAND_SAMSUNG_LP_OPTIONS; nand->eccmode = NAND_ECC_SOFT; nand->hwcontrol = netstar_nand_hwcontrol; -/* nand->dev_ready = netstar_nand_ready; */ - nand->chip_delay = 18; + nand->chip_delay = 400; return 0; } #endif diff --git a/include/configs/netstar.h b/include/configs/netstar.h index 33159d3156..a48893d1eb 100644 --- a/include/configs/netstar.h +++ b/include/configs/netstar.h @@ -48,14 +48,15 @@ #define CONFIG_SETUP_MEMORY_TAGS 1 #define CONFIG_INITRD_TAG 1 -#define CFG_DEVICE_NULLDEV 1 /* enable null device */ #define CONFIG_SILENT_CONSOLE 1 /* enable silent startup */ +#define CFG_CONSOLE_INFO_QUIET /* * Physical Memory Map */ #define CONFIG_NR_DRAM_BANKS 1 /* we have 1 bank of DRAM */ #define PHYS_SDRAM_1 0x10000000 /* SDRAM Bank #1 */ +#define PHYS_SDRAM_1_SIZE (64 * 1024 * 1024) #define PHYS_FLASH_1 0x00000000 /* Flash Bank #1 */ /* @@ -63,30 +64,21 @@ */ #define CFG_FLASH_BASE PHYS_FLASH_1 #define CFG_MAX_FLASH_BANKS 1 -#if (PHYS_SDRAM_1_SIZE == SZ_32M) -/*#if 1*/ -#define CFG_FLASH_CFI /* Flash is CFI conformant */ -#define CFG_FLASH_CFI_DRIVER /* Use the common driver */ -#define CFG_FLASH_EMPTY_INFO -#define CFG_MAX_FLASH_SECT 128 -#else -#define PHYS_FLASH_1_SIZE SZ_1M +#define PHYS_FLASH_1_SIZE (1 * 1024 * 1024) #define CFG_MAX_FLASH_SECT 19 #define CFG_FLASH_ERASE_TOUT (5*CFG_HZ) /* in ticks */ #define CFG_FLASH_WRITE_TOUT (5*CFG_HZ) -#endif #define CFG_MONITOR_BASE PHYS_FLASH_1 -#define CFG_MONITOR_LEN SZ_256K +#define CFG_MONITOR_LEN (256 * 1024) /* * Environment settings */ #define CFG_ENV_IS_IN_FLASH -#define ENV_IS_SOLITARY #define CFG_ENV_ADDR 0x4000 -#define CFG_ENV_SIZE SZ_8K -#define CFG_ENV_SECT_SIZE SZ_8K +#define CFG_ENV_SIZE (8 * 1024) +#define CFG_ENV_SECT_SIZE (8 * 1024) #define CFG_ENV_ADDR_REDUND 0x6000 #define CFG_ENV_SIZE_REDUND CFG_ENV_SIZE #define CONFIG_ENV_OVERWRITE @@ -95,14 +87,12 @@ * Size of malloc() pool */ #define CFG_GBL_DATA_SIZE 128 /* size in bytes reserved for initial data */ -/* XXX #define CFG_MALLOC_LEN (SZ_64K - CFG_GBL_DATA_SIZE)*/ -#define CFG_MALLOC_LEN SZ_4M +#define CFG_MALLOC_LEN (4 * 1024 * 1024) /* * The stack size is set up in start.S using the settings below */ -/* XXX #define CONFIG_STACKSIZE SZ_8K /XXX* regular stack */ -#define CONFIG_STACKSIZE SZ_1M /* regular stack */ +#define CONFIG_STACKSIZE (1 * 1024 * 1024) /* regular stack */ /* * Hardware drivers @@ -132,13 +122,16 @@ #define CFG_MAX_NAND_DEVICE 1 #define NAND_MAX_CHIPS 1 #define CFG_NAND_BASE 0x04000000 + (2 << 23) +#define NAND_ALLOW_ERASE_ALL 1 /* - * JFFS2 partitions (mtdparts command line support) + * partitions (mtdparts command line support) */ #define CONFIG_JFFS2_CMDLINE #define MTDIDS_DEFAULT "nor0=omapflash.0,nand0=omapnand.0" -#define MTDPARTS_DEFAULT "mtdparts=omapflash.0:8k@16k(env),8k(r_env),448k@576k(u-boot);omapnand.0:48M(rootfs0),48M(rootfs1),-(data)" +#define MTDPARTS_DEFAULT "mtdparts=" \ + "omapflash.0:8k@16k(env),8k(r_env),448k@576k(u-boot);" \ + "omapnand.0:4M(kernel0),40M(rootfs0),4M(kernel1),40M(rootfs1),-(data)" /* @@ -176,36 +169,34 @@ #define CONFIG_ZERO_BOOTDELAY_CHECK /* allow to break in always */ #undef CONFIG_BOOTARGS /* the boot command will set bootargs*/ #define CFG_AUTOLOAD "n" /* No autoload */ -#define CONFIG_BOOTCOMMAND "run nboot" +#define CONFIG_BOOTCOMMAND "run fboot" #define CONFIG_PREBOOT "run setup" -#define CONFIG_EXTRA_ENV_SETTINGS \ - "setup=setenv bootargs console=ttyS0,$baudrate " \ - "$mtdparts\0" \ - "ospart=0\0" \ - "setpart=" \ - "if test -n $swapos; then " \ - "if test $ospart -eq 0; then chpart nand0,1; else chpart nand0,0; fi; "\ - "setenv swapos; saveenv; " \ - "else " \ - "chpart nand0,$ospart; " \ - "fi\0" \ - "nfsargs=setenv bootargs $bootargs " \ - "ip=$ipaddr:$serverip:$gatewayip:$netmask:$hostname::off " \ - "nfsroot=$rootpath root=/dev/nfs\0" \ - "flashargs=run setpart;setenv bootargs $bootargs " \ - "root=/dev/mtdblock$partition ro " \ - "rootfstype=jffs2\0" \ - "initrdargs=setenv bootargs $bootargs " \ - "ip=$ipaddr:$serverip:$gatewayip:$netmask:$hostname::off\0" \ - "iboot=bootp;run initrdargs;tftp;bootm\0" \ - "fboot=run flashargs;fsload /boot/uImage;bootm\0" \ - "nboot=bootp;run nfsargs;tftp;bootm\0" +#define CONFIG_EXTRA_ENV_SETTINGS \ + "autostart=yes\0" \ + "ospart=0\0" \ + "setup=setenv bootargs console=ttyS0,$baudrate " \ + "$mtdparts\0" \ + "setpart=" \ + "if test -n $swapos; then " \ + "setenv swapos; saveenv; " \ + "else " \ + "if test $ospart -eq 0; then setenv ospart 1;" \ + "else setenv ospart 0; fi; " \ + "fi\0" \ + "nfsargs=setenv bootargs $bootargs " \ + "ip=$ipaddr:$serverip:$gatewayip:$netmask:$hostname::off " \ + "nfsroot=$rootpath root=/dev/nfs\0" \ + "flashargs=run setpart;setenv bootargs $bootargs " \ + "root=mtd:rootfs$ospart ro " \ + "rootfstype=jffs2\0" \ + "ip=$ipaddr:$serverip:$gatewayip:$netmask:$hostname::off\0" \ + "fboot=run flashargs;nboot kernel$ospart\0" \ + "nboot=bootp;run nfsargs;tftp\0" #if 0 /* feel free to disable for development */ #define CONFIG_AUTOBOOT_KEYED /* Enable password protection */ -#define CONFIG_AUTOBOOT_PROMPT "\nNetStar PBX - boot in %d sec...\n" -#define CONFIG_AUTOBOOT_DELAY_STR "R" /* 1st "password" */ -#define CONFIG_BOOT_RETRY_TIME 30 +#define CONFIG_AUTOBOOT_PROMPT "\nNetStar PBX - boot in %d secs...\n" +#define CONFIG_AUTOBOOT_DELAY_STR "." /* 1st "password" */ #endif /* @@ -223,7 +214,8 @@ #define CONFIG_AUTO_COMPLETE #define CFG_MEMTEST_START PHYS_SDRAM_1 -#define CFG_MEMTEST_END PHYS_SDRAM_1 + PHYS_SDRAM_1_SIZE +#define CFG_MEMTEST_END PHYS_SDRAM_1 + PHYS_SDRAM_1_SIZE - \ + (CFG_MONITOR_LEN + CFG_MALLOC_LEN + CONFIG_STACKSIZE) #undef CFG_CLKS_IN_HZ /* everything, incl board info, in Hz */