From: Hans de Goede Date: Fri, 14 Nov 2014 15:27:07 +0000 (+0100) Subject: sunxi: ahci: Add a delay after enabling target power X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=f222c73afaaa2430f700f56e7f3b6d8889b96e8c;p=u-boot.git sunxi: ahci: Add a delay after enabling target power If the target power is connected through a gpio, then give the target some time to power up before continuing with ahci / sata probing, this avoids link timeouts, without penalizing other boards where there is no target power gpio. Why 500 ms ? I started with 200, that was not enough, then I went to 500 which worked, lowering it to 350 broke things again, so 500 seems the minimum my vertex2 needs to be ready to get probed. Signed-off-by: Hans de Goede Acked-by: Ian Campbell --- diff --git a/board/sunxi/ahci.c b/board/sunxi/ahci.c index 5e123285b0..b7f0dda205 100644 --- a/board/sunxi/ahci.c +++ b/board/sunxi/ahci.c @@ -76,6 +76,8 @@ void scsi_init(void) #ifdef CONFIG_SATAPWR gpio_request(CONFIG_SATAPWR, "satapwr"); gpio_direction_output(CONFIG_SATAPWR, 1); + /* Give attached sata device time to power-up to avoid link timeouts */ + mdelay(500); #endif if (sunxi_ahci_phy_init(SUNXI_SATA_BASE) < 0)