From: Andre Przywara Date: Wed, 13 Jul 2022 15:27:57 +0000 (+0100) Subject: sunxi: h616: lower SPL stack address to avoid BROM data X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=eb53e7743c8fde2ff6b47b54075086154b0126c1;p=u-boot.git sunxi: h616: lower SPL stack address to avoid BROM data When using the USB OTG FEL mode on the Allwinner H616, the BootROM stores some data at the end of SRAM C. This is also the location where we place the initial SPL stack, so it will overwrite this data. We still need the BROM code after running the SPL, so should leave that area alone. Interestingly this does not seem to have an adverse effect, I guess on the "way out" (when we return to FEL after the SPL has run), this data is not needed by the BROM, for just the trailing end of the USB operation. However this is still wrong, and we should not clobber BROM data. Lower the SPL stack address to be situated right below the swap buffers we use in sunxi-fel: that should be out of the way of everyone else. Signed-off-by: Andre Przywara Reviewed-by: Samuel Holland Tested-by: Samuel Holland --- diff --git a/include/configs/sunxi-common.h b/include/configs/sunxi-common.h index 8032abe769..d2d70f0fc2 100644 --- a/include/configs/sunxi-common.h +++ b/include/configs/sunxi-common.h @@ -88,7 +88,7 @@ #endif /* !CONFIG_ARM64 */ #elif CONFIG_SUNXI_SRAM_ADDRESS == 0x20000 #ifdef CONFIG_MACH_SUN50I_H616 -#define LOW_LEVEL_SRAM_STACK 0x58000 +#define LOW_LEVEL_SRAM_STACK 0x52a00 /* below FEL buffers */ #else /* end of SRAM A2 on H6 for now */ #define LOW_LEVEL_SRAM_STACK 0x00118000