From: Chen-Yu Tsai Date: Fri, 3 Oct 2014 12:16:21 +0000 (+0800) Subject: ARM: sunxi: Use macro values for setting UART GPIO pull-ups X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=ea520947b125ebd7ce63fae2cbfb6937727eae0a;p=u-boot.git ARM: sunxi: Use macro values for setting UART GPIO pull-ups We have already defined macros for pull-up/down values in the GPIO header. Use them instead of magic numbers when configuring the UART pins. Signed-off-by: Chen-Yu Tsai Acked-by: Ian Campbell --- diff --git a/arch/arm/cpu/armv7/sunxi/board.c b/arch/arm/cpu/armv7/sunxi/board.c index f2cedbb156..95a74c5c06 100644 --- a/arch/arm/cpu/armv7/sunxi/board.c +++ b/arch/arm/cpu/armv7/sunxi/board.c @@ -53,15 +53,15 @@ int gpio_init(void) #if CONFIG_CONS_INDEX == 1 && (defined(CONFIG_SUN4I) || defined(CONFIG_SUN7I)) sunxi_gpio_set_cfgpin(SUNXI_GPB(22), SUN4I_GPB22_UART0_TX); sunxi_gpio_set_cfgpin(SUNXI_GPB(23), SUN4I_GPB23_UART0_RX); - sunxi_gpio_set_pull(SUNXI_GPB(23), 1); + sunxi_gpio_set_pull(SUNXI_GPB(23), SUNXI_GPIO_PULL_UP); #elif CONFIG_CONS_INDEX == 1 && defined(CONFIG_SUN5I) sunxi_gpio_set_cfgpin(SUNXI_GPB(19), SUN5I_GPB19_UART0_TX); sunxi_gpio_set_cfgpin(SUNXI_GPB(20), SUN5I_GPB20_UART0_RX); - sunxi_gpio_set_pull(SUNXI_GPB(20), 1); + sunxi_gpio_set_pull(SUNXI_GPB(20), SUNXI_GPIO_PULL_UP); #elif CONFIG_CONS_INDEX == 2 && defined(CONFIG_SUN5I) sunxi_gpio_set_cfgpin(SUNXI_GPG(3), SUN5I_GPG3_UART1_TX); sunxi_gpio_set_cfgpin(SUNXI_GPG(4), SUN5I_GPG4_UART1_RX); - sunxi_gpio_set_pull(SUNXI_GPG(4), 1); + sunxi_gpio_set_pull(SUNXI_GPG(4), SUNXI_GPIO_PULL_UP); #else #error Unsupported console port number. Please fix pin mux settings in board.c #endif