From: Konstantin Porotchkin Date: Wed, 29 Aug 2018 08:56:16 +0000 (+0300) Subject: nand: pxa3xx: cosmetic: add comments to the timing layout structures X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=e9a0777f851c3ffa5ece59921427d89bab1d7506;p=u-boot.git nand: pxa3xx: cosmetic: add comments to the timing layout structures Add comments with timing parameter names and some details about nand layout fileds. Remove unneeded definition. Signed-off-by: Konstantin Porotchkin Reviewed-by: Igal Liberman Cc: Stefan Roese Cc: Simon Glass Signed-off-by: Stefan Roese --- diff --git a/drivers/mtd/nand/pxa3xx_nand.c b/drivers/mtd/nand/pxa3xx_nand.c index 50a7754640..0ccad39b28 100644 --- a/drivers/mtd/nand/pxa3xx_nand.c +++ b/drivers/mtd/nand/pxa3xx_nand.c @@ -61,7 +61,6 @@ DECLARE_GLOBAL_DATA_PTR; #define NDCR_NAND_MODE (0x0) #define NDCR_CLR_PG_CNT (0x1 << 20) #define NFCV1_NDCR_ARB_CNTL (0x1 << 19) -#define NFCV2_NDCR_STOP_ON_UNCOR (0x1 << 19) #define NDCR_RD_ID_CNT_MASK (0x7 << 16) #define NDCR_RD_ID_CNT(x) (((x) << 16) & NDCR_RD_ID_CNT_MASK) @@ -251,6 +250,17 @@ struct pxa3xx_nand_info { }; static struct pxa3xx_nand_timing timing[] = { + /* + * tCH Enable signal hold time + * tCS Enable signal setup time + * tWH ND_nWE high duration + * tWP ND_nWE pulse time + * tRH ND_nRE high duration + * tRP ND_nRE pulse width + * tR ND_nWE high to ND_nRE low for read + * tWHR ND_nWE high to ND_nRE low for status read + * tAR ND_ALE low to ND_nRE low delay + */ /*ch cs wh wp rh rp r whr ar */ { 40, 80, 60, 100, 80, 100, 90000, 400, 40, }, { 10, 0, 20, 40, 30, 40, 11123, 110, 10, }, @@ -260,6 +270,13 @@ static struct pxa3xx_nand_timing timing[] = { }; static struct pxa3xx_nand_flash builtin_flash_types[] = { + /* + * chip_id + * flash_width Width of Flash memory (DWIDTH_M) + * dfc_width Width of flash controller(DWIDTH_C) + * *timing + * http://www.linux-mtd.infradead.org/nand-data/nanddata.html + */ { 0x46ec, 16, 16, &timing[1] }, { 0xdaec, 8, 8, &timing[1] }, { 0xd7ec, 8, 8, &timing[1] }, @@ -1428,6 +1445,7 @@ static int pxa_ecc_init(struct pxa3xx_nand_info *info, ecc->size = info->chunk_size; ecc->layout = &ecc_layout_4KB_bch8bit; ecc->strength = 16; + } else if (strength == 8 && ecc_stepsize == 512 && page_size == 2048) { info->ecc_bch = 1; info->nfullchunks = 1; @@ -1441,6 +1459,7 @@ static int pxa_ecc_init(struct pxa3xx_nand_info *info, ecc->size = info->chunk_size; ecc->layout = &ecc_layout_2KB_bch8bit; ecc->strength = 16; + } else { dev_err(&info->pdev->dev, "ECC strength %d at page size %d is not supported\n",