From: Caleb Connolly Date: Mon, 15 Jul 2024 10:08:18 +0000 (+0200) Subject: power: regulator: qcom-rpmh-regulator: adjust structs for U-Boot X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=e651b4f1f64f9809ac67cdc1311d77cdcaf8950f;p=u-boot.git power: regulator: qcom-rpmh-regulator: adjust structs for U-Boot Switch to our linear_range helpers and remove unused/unsupported linux-isms. Acked-by: Sumit Garg Signed-off-by: Caleb Connolly --- diff --git a/drivers/power/regulator/qcom-rpmh-regulator.c b/drivers/power/regulator/qcom-rpmh-regulator.c index d0acee9f55..089623f3a2 100644 --- a/drivers/power/regulator/qcom-rpmh-regulator.c +++ b/drivers/power/regulator/qcom-rpmh-regulator.c @@ -103,11 +103,10 @@ struct linear_range { * @regulator_type: RPMh accelerator type used to manage this * regulator * @ops: Pointer to regulator ops callback structure - * @voltage_ranges: The possible ranges of voltages supported by this - * PMIC regulator type - * @n_linear_ranges: Number of entries in voltage_ranges + * @voltage_range: The single range of voltages supported by this + * PMIC regulator type * @n_voltages: The number of unique voltage set points defined - * by voltage_ranges + * by voltage_range * @hpm_min_load_uA: Minimum load current in microamps that requires * high power mode (HPM) operation. This is used * for LDO hardware type regulators only. @@ -120,13 +119,13 @@ struct linear_range { */ struct rpmh_vreg_hw_data { enum rpmh_regulator_type regulator_type; - const struct regulator_ops *ops; - const struct linear_range *voltage_ranges; - int n_linear_ranges; + const struct dm_regulator_ops *ops; + struct linear_range voltage_range; int n_voltages; int hpm_min_load_uA; - const int *pmic_mode_map; - unsigned int (*of_map_mode)(unsigned int mode); + struct dm_regulator_mode *pmic_mode_map; + int n_modes; + unsigned int (*of_map_mode)(unsigned int mode); }; /** @@ -149,21 +148,20 @@ struct rpmh_vreg_hw_data { * @bypassed: Boolean indicating if the regulator is in * bypass (pass-through) mode or not. This is * only used by BOB rpmh-regulator resources. - * @voltage_selector: Selector used for get_voltage_sel() and - * set_voltage_sel() callbacks + * @uv: Selector used for get_voltage_sel() and + * set_value() callbacks * @mode: RPMh VRM regulator current framework mode */ struct rpmh_vreg { - struct device *dev; + struct udevice *dev; u32 addr; - struct regulator_desc rdesc; const struct rpmh_vreg_hw_data *hw_data; bool always_wait_for_ack; int enabled; bool bypassed; - int voltage_selector; - unsigned int mode; + int uv; + int mode; }; /**