From: Bastian Ruppert Date: Tue, 4 Oct 2011 23:43:33 +0000 (+0000) Subject: Davinci: ea20: add gpio for keeping power on in board_late_init X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=e5ee9125ecff23f337f26834c07a1f0252378818;p=u-boot.git Davinci: ea20: add gpio for keeping power on in board_late_init The pin called HALTEN drives a transistor to operate the supply voltage. After HALTEN is high, the user can release the power switch button and the device will stay powered on. Signed-off-by: Bastian Ruppert CC: sbabic@denx.de CC: dzu@denx.de Signed-off-by: Sandeep Paulraj --- diff --git a/board/davinci/ea20/ea20.c b/board/davinci/ea20/ea20.c index da9086a527..1a57baf4e2 100644 --- a/board/davinci/ea20/ea20.c +++ b/board/davinci/ea20/ea20.c @@ -98,6 +98,10 @@ const struct pinmux_config gpio_pins[] = { { pinmux(13), 8, 3 } /* GPIO6[12] U0_SW1 on EA20-00101_2*/ }; +const struct pinmux_config halten_pin[] = { + { pinmux(3), 4, 2 } /* GPIO8[6] HALTEN */ +}; + static const struct pinmux_resource pinmuxes[] = { #ifdef CONFIG_SPI_FLASH PINMUX_ITEM(spi1_pins), @@ -205,6 +209,27 @@ int board_init(void) return 0; } + +#ifdef BOARD_LATE_INIT + +int board_late_init(void) +{ + struct davinci_gpio *gpio8_base = + (struct davinci_gpio *)DAVINCI_GPIO_BANK8; + + /* PinMux for HALTEN */ + if (davinci_configure_pin_mux(halten_pin, ARRAY_SIZE(halten_pin)) != 0) + return 1; + + /* Set HALTEN to high */ + writel((readl(&gpio8_base->set_data) | (1 << 6)), + &gpio8_base->set_data); + writel((readl(&gpio8_base->dir) & ~(1 << 6)), &gpio8_base->dir); + + return 0; +} +#endif /* BOARD_LATE_INIT */ + #ifdef CONFIG_DRIVER_TI_EMAC /* diff --git a/include/configs/ea20.h b/include/configs/ea20.h index d86207a3b2..916ad00541 100644 --- a/include/configs/ea20.h +++ b/include/configs/ea20.h @@ -31,6 +31,7 @@ #define CONFIG_SYS_USE_NAND #define CONFIG_DRIVER_TI_EMAC_USE_RMII #define CONFIG_BOARD_EARLY_INIT_F +#define BOARD_LATE_INIT /* * SoC Configuration