From: Heiko Stuebner Date: Fri, 21 Sep 2018 08:59:48 +0000 (+0200) Subject: rockchip: rk3188: explicitly set vcc_sd0 pin to gpio on rk3188-radxarock X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=e4d5fa3db0b9ad6551752f90b153d64706bbddef;p=u-boot.git rockchip: rk3188: explicitly set vcc_sd0 pin to gpio on rk3188-radxarock It is good practice to make the setting of gpio-pinctrls explicitly in the devicetree, and in this case even necessary. Rockchip boards start with iomux settings set to gpio for most pins and while the linux pinctrl driver also implicitly sets the gpio function if a pin is requested as gpio that is not necessarily true for other drivers. The issue in question stems from uboot, where the sdmmc_pwr pin is set to function 1 (sdmmc-power) by the bootrom when reading the 1st-stage loader. The regulator controlled by the pin is active-low though, so when the dwmmc hw-block sets its enabled bit, it actually disables the regulator. By changing the pin back to gpio we fix that behaviour. [picked from the identical linux patch https://patchwork.kernel.org/patch/10609253/] Signed-off-by: Heiko Stuebner Reviewed-by: Philipp Tomsich Acked-by: Philipp Tomsich --- diff --git a/arch/arm/dts/rk3188-radxarock.dts b/arch/arm/dts/rk3188-radxarock.dts index ac931e14af..61367126ba 100644 --- a/arch/arm/dts/rk3188-radxarock.dts +++ b/arch/arm/dts/rk3188-radxarock.dts @@ -104,6 +104,8 @@ regulator-min-microvolt = <3300000>; regulator-max-microvolt = <3300000>; gpio = <&gpio3 1 GPIO_ACTIVE_LOW>; + pinctrl-names = "default"; + pinctrl-0 = <&sdmmc_pwr>; startup-delay-us = <100000>; vin-supply = <&vcc_io>; }; @@ -334,6 +336,12 @@ }; }; + sd0 { + sdmmc_pwr: sdmmc-pwr { + rockchip,pins = ; + }; + }; + usb { host_vbus_drv: host-vbus-drv { rockchip,pins = <0 3 RK_FUNC_GPIO &pcfg_pull_none>;