From: Bryan Brattlof Date: Fri, 29 Dec 2023 17:47:21 +0000 (-0600) Subject: arm: dts: k3-am654: move dummy_clock to root node X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=e055622bd7f42810b2f329ec60596dfa62952d69;p=u-boot.git arm: dts: k3-am654: move dummy_clock to root node The dummy_clock node is used to help the drivers probe the IO needed to setup consoles and boot media to load firmware into the SoC. This dummy_clock isn't a device that exists nor does it exist in the mcu domain. So move it from cbass_mcu to the root node to avoid any confusion. Tested-by: Tom Rini Signed-off-by: Bryan Brattlof Reviewed-by: Nishanth Menon --- diff --git a/arch/arm/dts/k3-am654-r5-base-board.dts b/arch/arm/dts/k3-am654-r5-base-board.dts index 9926981c66..b27b2b05ad 100644 --- a/arch/arm/dts/k3-am654-r5-base-board.dts +++ b/arch/arm/dts/k3-am654-r5-base-board.dts @@ -30,6 +30,13 @@ ti,sci-host-id = <10>; bootph-pre-ram; }; + + clk_200mhz: dummy_clock { + compatible = "fixed-clock"; + #clock-cells = <0>; + clock-frequency = <200000000>; + bootph-pre-ram; + }; }; &cbass_mcu { @@ -51,13 +58,6 @@ mbox-names = "tx", "rx"; bootph-pre-ram; }; - - clk_200mhz: dummy_clock { - compatible = "fixed-clock"; - #clock-cells = <0>; - clock-frequency = <200000000>; - bootph-pre-ram; - }; }; /*