From: Paul Burton Date: Tue, 17 May 2016 06:43:26 +0000 (+0100) Subject: dm: ns16550: Don't map_physmem for I/O ports X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=df8ec55d52c74a9c73df549da846f5e6c5acb5ab;p=u-boot.git dm: ns16550: Don't map_physmem for I/O ports If the UART is to be accessed using I/O port accessors (inb & outb) then using map_physmem doesn't make sense, since it operates in a different memory space. Remove the call to map_physmem when CONFIG_SYS_NS16550_PORT_MAPPED is defined, allowing I/O port addresses to not be mangled by the incorrect mapping. Signed-off-by: Paul Burton Signed-off-by: Daniel Schwierzeck --- diff --git a/drivers/serial/ns16550.c b/drivers/serial/ns16550.c index 28da9ddfd8..d7a3cf665e 100644 --- a/drivers/serial/ns16550.c +++ b/drivers/serial/ns16550.c @@ -100,7 +100,8 @@ static void ns16550_writeb(NS16550_t port, int offset, int value) unsigned char *addr; offset *= 1 << plat->reg_shift; - addr = map_physmem(plat->base, 0, MAP_NOCACHE) + offset; + addr = (unsigned char *)plat->base + offset; + /* * As far as we know it doesn't make sense to support selection of * these options at run-time, so use the existing CONFIG options. @@ -114,7 +115,7 @@ static int ns16550_readb(NS16550_t port, int offset) unsigned char *addr; offset *= 1 << plat->reg_shift; - addr = map_physmem(plat->base, 0, MAP_NOCACHE) + offset; + addr = (unsigned char *)plat->base + offset; return serial_in_shift(addr + plat->reg_offset, plat->reg_shift); } @@ -400,7 +401,12 @@ int ns16550_serial_ofdata_to_platdata(struct udevice *dev) if (addr == FDT_ADDR_T_NONE) return -EINVAL; +#ifdef CONFIG_SYS_NS16550_PORT_MAPPED plat->base = addr; +#else + plat->base = (unsigned long)map_physmem(addr, 0, MAP_NOCACHE); +#endif + plat->reg_offset = fdtdec_get_int(gd->fdt_blob, dev->of_offset, "reg-offset", 0); plat->reg_shift = fdtdec_get_int(gd->fdt_blob, dev->of_offset,