From: Hannes Petermaier Date: Tue, 3 Feb 2015 12:22:27 +0000 (+0100) Subject: board/BuR/common: try to setup cpsw mac-address from the devicetree X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=d301425fbfc7a0c13df2a2965a289c829e2b1ba3;p=u-boot.git board/BuR/common: try to setup cpsw mac-address from the devicetree since we have a dtb blob programmed on the board we try to setup the cpsw interface with the programmed mac. If this method fails, we fall back to the device-fuses. Signed-off-by: Hannes Petermaier --- diff --git a/board/BuR/common/common.c b/board/BuR/common/common.c index 7d0e05ce7c..18e1520b38 100644 --- a/board/BuR/common/common.c +++ b/board/BuR/common/common.c @@ -591,9 +591,9 @@ static struct cpsw_platform_data cpsw_data = { int board_eth_init(bd_t *bis) { int rv = 0; - uint8_t mac_addr[6]; + char mac_addr[6]; + const char *mac = 0; uint32_t mac_hi, mac_lo; - /* try reading mac address from efuse */ mac_lo = readl(&cdev->macid0l); mac_hi = readl(&cdev->macid0h); @@ -607,14 +607,19 @@ int board_eth_init(bd_t *bis) #if (defined(CONFIG_DRIVER_TI_CPSW) && !defined(CONFIG_SPL_BUILD)) || \ (defined(CONFIG_SPL_ETH_SUPPORT) && defined(CONFIG_SPL_BUILD)) if (!getenv("ethaddr")) { - printf(" not set. Validating first E-fuse MAC ... "); - - if (is_valid_ether_addr(mac_addr)) { - printf("using: %02X:%02X:%02X:%02X:%02X:%02X.\n", - mac_addr[0], mac_addr[1], mac_addr[2], - mac_addr[3], mac_addr[4], mac_addr[5] - ); - eth_setenv_enetaddr("ethaddr", mac_addr); + #if !defined(CONFIG_SPL_BUILD) && defined(CONFIG_USE_FDT) + printf(" not set. trying DTB ... "); + mac = dtbmacaddr(0); + #endif + if (!mac) { + printf(" not set. validating E-fuse MAC ... "); + if (is_valid_ether_addr((const u8 *)mac_addr)) + mac = (const char *)mac_addr; + } + + if (mac) { + printf("using: %pM on ", mac); + eth_setenv_enetaddr("ethaddr", (const u8 *)mac); } } writel(MII_MODE_ENABLE, &cdev->miisel);