From: Stephen Warren Date: Sun, 8 Mar 2015 17:08:13 +0000 (-0600) Subject: usb: dwc2: fix aligned buffer usage X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=d1c880c66c2f4d676afd91ce041a3e66c2ab3fa4;p=u-boot.git usb: dwc2: fix aligned buffer usage The original aligned_buffer usage: a) Uselessly copied data into the aligned buffer even for IN transactions. Fix this my making the copy conditional. b) Always programmed the HW to transfer to/from the start of the aligned buffer. This worked fine for OUT transactions since the memcpy copied the OUT data to this location too. However, for large IN transactions, since the copy from the aligned buffer to the "client" buffer was deferred until after all chunks were transferred. it resulted in each chunk's transfer over-writing the data for the first transfer. Fix this by copying IN data as soon as it's received. Signed-off-by: Stephen Warren --- diff --git a/drivers/usb/host/dwc2.c b/drivers/usb/host/dwc2.c index 5a1c44a8fb..05d21b7948 100644 --- a/drivers/usb/host/dwc2.c +++ b/drivers/usb/host/dwc2.c @@ -795,7 +795,9 @@ int chunk_msg(struct usb_device *dev, unsigned long pipe, int *pid, int in, (*pid << DWC2_HCTSIZ_PID_OFFSET), &hc_regs->hctsiz); - memcpy(aligned_buffer, (char *)buffer + done, len - done); + if (!in) + memcpy(aligned_buffer, (char *)buffer + done, len); + writel((uint32_t)aligned_buffer, &hc_regs->hcdma); /* Set host channel enable after all other setup is complete. */ @@ -810,16 +812,16 @@ int chunk_msg(struct usb_device *dev, unsigned long pipe, int *pid, int in, break; } - done += xfer_len; if (in) { - done -= sub; + xfer_len -= sub; + memcpy(buffer + done, aligned_buffer, xfer_len); if (sub) stop_transfer = 1; } - } while ((done < len) && !stop_transfer); - if (done && in) - memcpy(buffer, aligned_buffer, done); + done += xfer_len; + + } while ((done < len) && !stop_transfer); writel(0, &hc_regs->hcintmsk); writel(0xFFFFFFFF, &hc_regs->hcint);