From: Michal Simek <michal.simek@xilinx.com>
Date: Wed, 28 Aug 2013 06:26:41 +0000 (+0200)
Subject: arm: zynq: Do not remap OCM to high address
X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=c1824ea268b1a565fd6956d79a91e4460d88a88b;p=u-boot.git

arm: zynq: Do not remap OCM to high address

In case where ps-ddr is not used, do not remap
OCM to high address and keep it from 0x0.
Linux SMP requires to have memory at 0x0.

Signed-off-by: Michal Simek <michal.simek@xilinx.com>
---

diff --git a/arch/arm/cpu/armv7/zynq/cpu.c b/arch/arm/cpu/armv7/zynq/cpu.c
index 2bb38438ae..0ca5d8a97a 100644
--- a/arch/arm/cpu/armv7/zynq/cpu.c
+++ b/arch/arm/cpu/armv7/zynq/cpu.c
@@ -16,13 +16,15 @@ void lowlevel_init(void)
 int arch_cpu_init(void)
 {
 	zynq_slcr_unlock();
-	/* remap DDR to zero, FILTERSTART */
-	writel(0, &scu_base->filter_start);
 
 	/* Device config APB, unlock the PCAP */
 	writel(0x757BDF0D, &devcfg_base->unlock);
 	writel(0xFFFFFFFF, &devcfg_base->rom_shadow);
 
+#if (CONFIG_SYS_SDRAM_BASE == 0)
+	/* remap DDR to zero, FILTERSTART */
+	writel(0, &scu_base->filter_start);
+
 	/* OCM_CFG, Mask out the ROM, map ram into upper addresses */
 	writel(0x1F, &slcr_base->ocm_cfg);
 	/* FPGA_RST_CTRL, clear resets on AXI fabric ports */
@@ -33,6 +35,7 @@ int arch_cpu_init(void)
 	writel(0x0, &slcr_base->ddr_urgent_sel);
 	/* Urgent write, ports S2/S3 */
 	writel(0xC, &slcr_base->ddr_urgent);
+#endif
 
 	zynq_slcr_lock();