From: Manorit Chawdhry <m-chawdhry@ti.com>
Date: Thu, 18 May 2023 07:14:17 +0000 (+0530)
Subject: arm: mach-k3: security: separate out validating binary logic
X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=bd6a247593742596a83d6e36bebb45cb78a4017e;p=u-boot.git

arm: mach-k3: security: separate out validating binary logic

K3 GP devices allows booting the secure binaries on them by bypassing
the x509 header on them.

ATF and OPTEE firewalling required the rproc_load to be called before
authentication. This change caused the failure for GP devices that
strips off the headers. The boot vector had been set before the headers
were stripped off causing the runtime stripping to fail and stripping
becoming in-effective.

Separate out the secure binary check on GP/HS devices so that the
boot_vector could be stripped before calling rproc_load. This allows
keeping the authentication later when the cluster is on along with
allowing the stripping of the binaries in case of gp devices.

Fixes: 1e00e9be62e5 ("arm: mach-k3: common: re-locate authentication for atf/optee")

Signed-off-by: Manorit Chawdhry <m-chawdhry@ti.com>
---

diff --git a/arch/arm/mach-k3/common.c b/arch/arm/mach-k3/common.c
index 3c85caee57..34737a43aa 100644
--- a/arch/arm/mach-k3/common.c
+++ b/arch/arm/mach-k3/common.c
@@ -347,8 +347,13 @@ void board_fit_image_post_process(const void *fit, int node, void **p_image,
 	if ((i != IMAGE_ID_ATF) && (i != IMAGE_ID_OPTEE))
 #endif
 	{
+		ti_secure_image_check_binary(p_image, p_size);
 		ti_secure_image_post_process(p_image, p_size);
 	}
+#if IS_ENABLED(CONFIG_SYS_K3_SPL_ATF)
+	else
+		ti_secure_image_check_binary(p_image, p_size);
+#endif
 }
 #endif
 
diff --git a/arch/arm/mach-k3/common.h b/arch/arm/mach-k3/common.h
index e7e59f533b..899be64a50 100644
--- a/arch/arm/mach-k3/common.h
+++ b/arch/arm/mach-k3/common.h
@@ -41,3 +41,4 @@ enum k3_device_type get_device_type(void);
 void ti_secure_image_post_process(void **p_image, size_t *p_size);
 struct ti_sci_handle *get_ti_sci_handle(void);
 void do_board_detect(void);
+void ti_secure_image_check_binary(void **p_image, size_t *p_size);
diff --git a/arch/arm/mach-k3/security.c b/arch/arm/mach-k3/security.c
index 6179f7373a..02a2c12dbd 100644
--- a/arch/arm/mach-k3/security.c
+++ b/arch/arm/mach-k3/security.c
@@ -38,19 +38,16 @@ static size_t ti_secure_cert_length(void *p_image)
 	return seq_length + 4;
 }
 
-void ti_secure_image_post_process(void **p_image, size_t *p_size)
+void ti_secure_image_check_binary(void **p_image, size_t *p_size)
 {
-	struct ti_sci_handle *ti_sci = get_ti_sci_handle();
-	struct ti_sci_proc_ops *proc_ops = &ti_sci->ops.proc_ops;
-	size_t cert_length;
-	u64 image_addr;
 	u32 image_size;
-	int ret;
-
+	size_t cert_length;
 	image_size = *p_size;
 
-	if (!image_size)
+	if (!image_size) {
+		debug("%s: Image size is %d\n", __func__, image_size);
 		return;
+	}
 
 	if (get_device_type() == K3_DEVICE_TYPE_GP) {
 		if (ti_secure_cert_detected(*p_image)) {
@@ -78,6 +75,25 @@ void ti_secure_image_post_process(void **p_image, size_t *p_size)
 		       "This will fail on Security Enforcing(HS-SE) devices\n");
 		return;
 	}
+}
+
+void ti_secure_image_post_process(void **p_image, size_t *p_size)
+{
+	struct ti_sci_handle *ti_sci = get_ti_sci_handle();
+	struct ti_sci_proc_ops *proc_ops = &ti_sci->ops.proc_ops;
+	u64 image_addr;
+	u32 image_size;
+	int ret;
+
+	image_size = *p_size;
+	if (!image_size) {
+		debug("%s: Image size is %d\n", __func__, image_size);
+		return;
+	}
+
+	if (get_device_type() != K3_DEVICE_TYPE_HS_SE &&
+	    get_device_type() != K3_DEVICE_TYPE_HS_FS)
+		return;
 
 	/* Clean out image so it can be seen by system firmware */
 	image_addr = dma_map_single(*p_image, *p_size, DMA_BIDIRECTIONAL);