From: Heinrich Schuchardt Date: Sat, 1 Dec 2018 09:07:10 +0000 (+0100) Subject: doc: README.iscsi: Open-iSCSI configuration X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=b989648cf45d073674677f04ca2ac8b5f7618513;p=u-boot.git doc: README.iscsi: Open-iSCSI configuration Provide settings for Open-iSCSI Reformat headers. h3-headers marked with ^^^ are not recognized in some markup editors. Use the ### notation instead. Signed-off-by: Heinrich Schuchardt Signed-off-by: Alexander Graf --- diff --git a/doc/README.iscsi b/doc/README.iscsi index faee636264..3a12438f90 100644 --- a/doc/README.iscsi +++ b/doc/README.iscsi @@ -1,8 +1,6 @@ -iSCSI booting with U-Boot and iPXE -================================== +# iSCSI booting with U-Boot and iPXE -Motivation ----------- +## Motivation U-Boot has only a reduced set of supported network protocols. The focus for network booting has been on UDP based protocols. A TCP stack and HTTP support @@ -41,8 +39,7 @@ fine grained control of the boot process and can provide a command shell. iPXE can be built as an EFI application (named snp.efi) which can be loaded and run by U-Boot. -Boot sequence -------------- +## Boot sequence U-Boot loads the EFI application iPXE snp.efi using the bootefi command. This application has network access via the simple network protocol offered by @@ -106,19 +103,16 @@ the EFI stub Linux is called as an EFI application:: | | | ~ ~ ~ ~| -Security --------- +## Security The iSCSI protocol is not encrypted. The traffic could be secured using IPsec but neither U-Boot nor iPXE does support this. So we should at least separate the iSCSI traffic from all other network traffic. This can be achieved using a virtual local area network (VLAN). -Configuration -------------- +## Configuration -iPXE -^^^^ +### iPXE For running iPXE on arm64 the bin-arm64-efi/snp.efi build target is needed:: @@ -157,9 +151,20 @@ following into src/config/local/general.h is sufficient for most use cases:: #define DOWNLOAD_PROTO_NFS /* Network File System Protocol */ #define DOWNLOAD_PROTO_FILE /* Local file system access */ -Links ------ +### Open-iSCSI + +When the root file system is on an iSCSI drive you should disable pings and set +the replacement timer to a high value [3]: + + node.conn[0].timeo.noop_out_interval = 0 + node.conn[0].timeo.noop_out_timeout = 0 + node.session.timeo.replacement_timeout = 86400 + +## Links * [1](https://ipxe.org) https://ipxe.org - iPXE open source boot firmware * [2](https://www.gnu.org/software/grub/) https://www.gnu.org/software/grub/ - - GNU GRUB (Grand Unified Bootloader) + GNU GRUB (Grand Unified Bootloader) +* [3](https://github.com/open-iscsi/open-iscsi/blob/master/README) + https://github.com/open-iscsi/open-iscsi/blob/master/README - + Open-iSCSI README