From: Andre Przywara Date: Thu, 9 May 2024 23:13:16 +0000 (+0100) Subject: sunxi: spl: h616: fix booting from high MMC offset X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=a7766911bc2fc40df351564d71e6b93999c97b03;p=u-boot.git sunxi: spl: h616: fix booting from high MMC offset The BootROM in the Allwinner H616 tries to load the initial boot code from sector 16 (8KB) of an SD card or eMMC device, but also looks at sector 512 (256KB). This helps with GPT formatted cards. A "high" boot offset is also used on previous SoCs, but it's sector 256 (128KB) there instead. Extend the existing offset calculation code to consider the different sector offset when running on an H616 SoC. This allows to load U-Boot on any H616 device when the SPL is not located at 8KB. Signed-off-by: Andre Przywara Reviewed-by: Chen-Yu Tsai Tested-by: Ryan Walklin --- diff --git a/arch/arm/mach-sunxi/board.c b/arch/arm/mach-sunxi/board.c index 0140b07d32..046e9fbfc6 100644 --- a/arch/arm/mach-sunxi/board.c +++ b/arch/arm/mach-sunxi/board.c @@ -333,7 +333,8 @@ uint32_t sunxi_get_spl_size(void) * The eGON SPL image can be located at 8KB or at 128KB into an SD card or * an eMMC device. The boot source has bit 4 set in the latter case. * By adding 120KB to the normal offset when booting from a "high" location - * we can support both cases. + * we can support both cases. The H616 has the alternative location + * moved up to 256 KB instead of 128KB, so cater for that, too. * Also U-Boot proper is located at least 32KB after the SPL, but will * immediately follow the SPL if that is bigger than that. */ @@ -349,6 +350,8 @@ unsigned long board_spl_mmc_get_uboot_raw_sector(struct mmc *mmc, case SUNXI_BOOTED_FROM_MMC0_HIGH: case SUNXI_BOOTED_FROM_MMC2_HIGH: sector += (128 - 8) * 2; + if (IS_ENABLED(CONFIG_MACH_SUN50I_H616)) + sector += 128 * 2; break; }