From: Siva Durga Prasad Paladugu Date: Tue, 15 Nov 2016 10:45:42 +0000 (+0530) Subject: net: zynq_gem: Use clock driver for ZynqMP X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=a765bdd1cbf576b71502635cf1ebfb28fbad034e;p=u-boot.git net: zynq_gem: Use clock driver for ZynqMP Enable and use the clock driver routine defined in clock driver toset required clock appropriately. Signed-off-by: Siva Durga Prasad Paladugu Signed-off-by: Michal Simek --- diff --git a/arch/arm/include/asm/arch-zynqmp/sys_proto.h b/arch/arm/include/asm/arch-zynqmp/sys_proto.h index 1db2bd6a4f..95fd91da29 100644 --- a/arch/arm/include/asm/arch-zynqmp/sys_proto.h +++ b/arch/arm/include/asm/arch-zynqmp/sys_proto.h @@ -8,10 +8,12 @@ #ifndef _ASM_ARCH_SYS_PROTO_H #define _ASM_ARCH_SYS_PROTO_H +#ifndef CONFIG_CLK_ZYNQMP /* Setup clk for network */ static inline void zynq_slcr_gem_clk_setup(u32 gem_id, unsigned long clk_rate) { } +#endif int zynq_slcr_get_mio_pin_status(const char *periph); diff --git a/drivers/net/zynq_gem.c b/drivers/net/zynq_gem.c index 95b4d6e4f0..6dd87cf28f 100644 --- a/drivers/net/zynq_gem.c +++ b/drivers/net/zynq_gem.c @@ -9,6 +9,7 @@ * SPDX-License-Identifier: GPL-2.0+ */ +#include #include #include #include @@ -181,6 +182,9 @@ struct zynq_gem_priv { struct phy_device *phydev; int phy_of_handle; struct mii_dev *bus; +#ifdef CONFIG_CLK_ZYNQMP + struct clk clk; +#endif }; static u32 phy_setup_op(struct zynq_gem_priv *priv, u32 phy_addr, u32 regnum, @@ -455,8 +459,14 @@ static int zynq_gem_init(struct udevice *dev) /* Change the rclk and clk only not using EMIO interface */ if (!priv->emio) +#ifndef CONFIG_CLK_ZYNQMP zynq_slcr_gem_clk_setup((ulong)priv->iobase != ZYNQ_GEM_BASEADDR0, clk_rate); +#else + ret = clk_set_rate(&priv->clk, clk_rate); + if (IS_ERR_VALUE(ret)) + return -1; +#endif setbits_le32(®s->nwctrl, ZYNQ_GEM_NWCTRL_RXEN_MASK | ZYNQ_GEM_NWCTRL_TXEN_MASK); @@ -629,6 +639,14 @@ static int zynq_gem_probe(struct udevice *dev) priv->tx_bd = (struct emac_bd *)bd_space; priv->rx_bd = (struct emac_bd *)((ulong)bd_space + BD_SEPRN_SPACE); +#ifdef CONFIG_CLK_ZYNQMP + ret = clk_get_by_name(dev, "tx_clk", &priv->clk); + if (ret < 0) { + dev_err(dev, "failed to get clock\n"); + return -EINVAL; + } +#endif + priv->bus = mdio_alloc(); priv->bus->read = zynq_gem_miiphy_read; priv->bus->write = zynq_gem_miiphy_write;