From: Robert P. J. Day Date: Wed, 16 Dec 2015 16:31:23 +0000 (-0500) Subject: video: Clean up formatting, spelling mistakes in exynos_dp* X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=a418f7e8503cc791d04e5084eea9da9961d8ce43;p=u-boot.git video: Clean up formatting, spelling mistakes in exynos_dp* Aesthetic cleanup in drivers/video/exynos_dp*.[ch] files. Signed-off-by: Robert P. J. Day --- diff --git a/drivers/video/exynos_dp.c b/drivers/video/exynos_dp.c index 5b6fc140e0..0d5d090d0e 100644 --- a/drivers/video/exynos_dp.c +++ b/drivers/video/exynos_dp.c @@ -207,7 +207,7 @@ static unsigned int exynos_dp_handle_edid(struct edp_device_info *edp_info) return -EINVAL; } - /*Refer VESA Display Port Stnadard Ver1.1a Page 120 */ + /* Refer VESA Display Port Standard Ver1.1a Page 120 */ if (edp_info->dpcd_rev == DP_DPCD_REV_11) { temp = buf[DPCD_MAX_LANE_COUNT] & 0x1f; if (buf[DPCD_MAX_LANE_COUNT] & 0x80) @@ -270,7 +270,7 @@ static unsigned int exynos_dp_link_start(struct edp_device_info *edp_info) return ret; } - /* Set link rate and count as you want to establish*/ + /* Set link rate and count as you want to establish */ exynos_dp_set_link_bandwidth(edp_info->lane_bw); exynos_dp_set_lane_count(edp_info->lane_cnt); @@ -322,7 +322,7 @@ static unsigned int exynos_dp_training_pattern_dis(void) ret = exynos_dp_write_byte_to_dpcd(DPCD_TRAINING_PATTERN_SET, DPCD_TRAINING_PATTERN_DISABLED); if (ret != EXYNOS_DP_SUCCESS) { - printf("DP requst_link_traninig_req failed\n"); + printf("DP request_link_training_req failed\n"); return -EAGAIN; } @@ -412,7 +412,7 @@ static unsigned int exynos_dp_read_dpcd_adj_req(unsigned char lane_num, unsigned int dpcd_addr; unsigned char shift_val[DP_LANE_CNT_4] = {0, 4, 0, 4}; - /*lane_num value is used as arry index, so this range 0 ~ 3 */ + /* lane_num value is used as array index, so this range 0 ~ 3 */ dpcd_addr = DPCD_ADJUST_REQUEST_LANE0_1 + (lane_num / 2); ret = exynos_dp_read_byte_from_dpcd(dpcd_addr, &buf); @@ -433,7 +433,7 @@ static int exynos_dp_equalizer_err_link(struct edp_device_info *edp_info) ret = exynos_dp_training_pattern_dis(); if (ret != EXYNOS_DP_SUCCESS) { - printf("DP training_patter_disable() failed\n"); + printf("DP training_pattern_disable() failed\n"); edp_info->lt_info.lt_status = DP_LT_FAIL; } @@ -523,7 +523,7 @@ static unsigned int exynos_dp_process_clock_recovery(struct edp_device_info ret = exynos_dp_write_bytes_to_dpcd( DPCD_TRAINING_PATTERN_SET, 5, buf); if (ret != EXYNOS_DP_SUCCESS) { - printf("DP write traning pattern1 failed\n"); + printf("DP write training pattern1 failed\n"); edp_info->lt_info.lt_status = DP_LT_FAIL; return ret; } else @@ -567,7 +567,7 @@ static unsigned int exynos_dp_process_clock_recovery(struct edp_device_info ret = exynos_dp_write_bytes_to_dpcd( DPCD_TRAINING_LANE0_SET, 4, lt_ctl_val); if (ret != EXYNOS_DP_SUCCESS) { - printf("DP write traning pattern2 failed\n"); + printf("DP write training pattern2 failed\n"); edp_info->lt_info.lt_status = DP_LT_FAIL; return ret; } @@ -738,7 +738,7 @@ static unsigned int exynos_dp_set_link_train(struct edp_device_info *edp_info) ret = exynos_dp_sw_link_training(edp_info); if (ret != EXYNOS_DP_SUCCESS) - printf("DP dp_sw_link_traning() failed\n"); + printf("DP dp_sw_link_training() failed\n"); return ret; } diff --git a/drivers/video/exynos_dp_lowlevel.c b/drivers/video/exynos_dp_lowlevel.c index e9b461a99a..acb5bc8eb7 100644 --- a/drivers/video/exynos_dp_lowlevel.c +++ b/drivers/video/exynos_dp_lowlevel.c @@ -44,7 +44,7 @@ static void exynos_dp_enable_video_input(unsigned int enable) reg = readl(&dp_regs->video_ctl1); reg &= ~VIDEO_EN_MASK; - /* enable video input*/ + /* enable video input */ if (enable) reg |= VIDEO_EN_MASK; @@ -55,13 +55,13 @@ static void exynos_dp_enable_video_input(unsigned int enable) void exynos_dp_enable_video_bist(unsigned int enable) { - /*enable video bist*/ + /* enable video bist */ unsigned int reg; reg = readl(&dp_regs->video_ctl4); reg &= ~VIDEO_BIST_MASK; - /*enable video bist*/ + /* enable video bist */ if (enable) reg |= VIDEO_BIST_MASK; @@ -112,7 +112,7 @@ static void exynos_dp_init_analog_param(void) /* * Set AUX TX terminal resistor to 102 ohm * Set AUX channel amplitude control - */ + */ reg = PD_RING_OSC | AUX_TERMINAL_CTRL_52_OHM | TX_CUR1_2X | TX_CUR_4_MA; writel(reg, &dp_regs->pll_filter_ctl1); @@ -146,7 +146,7 @@ static void exynos_dp_init_interrupt(void) */ writel(INT_POL, &dp_regs->int_ctl); - /* Clear pending regisers */ + /* Clear pending registers */ writel(0xff, &dp_regs->common_int_sta1); writel(0xff, &dp_regs->common_int_sta2); writel(0xff, &dp_regs->common_int_sta3); @@ -165,7 +165,7 @@ void exynos_dp_reset(void) { unsigned int reg_func_1; - /*dp tx sw reset*/ + /* dp tx sw reset */ writel(RESET_DP_TX, &dp_regs->tx_sw_reset); exynos_dp_enable_video_input(DP_DISABLE); @@ -287,7 +287,7 @@ int exynos_dp_init_analog_func(void) unsigned int retry_cnt = 10; unsigned int reg; - /*Power On All Analog block */ + /* Power On All Analog block */ exynos_dp_set_analog_power_down(POWER_ALL, DP_DISABLE); reg = PLL_LOCK_CHG; @@ -297,14 +297,14 @@ int exynos_dp_init_analog_func(void) reg &= ~(F_PLL_LOCK | PLL_LOCK_CTRL); writel(reg, &dp_regs->debug_ctl); - /*Assert DP PLL Reset*/ + /* Assert DP PLL Reset */ reg = readl(&dp_regs->pll_ctl); reg |= DP_PLL_RESET; writel(reg, &dp_regs->pll_ctl); mdelay(1); - /*Deassert DP PLL Reset*/ + /* Deassert DP PLL Reset */ reg = readl(&dp_regs->pll_ctl); reg &= ~(DP_PLL_RESET); writel(reg, &dp_regs->pll_ctl); @@ -336,7 +336,7 @@ void exynos_dp_init_hpd(void) { unsigned int reg; - /* Clear interrupts releated to Hot Plug Dectect */ + /* Clear interrupts related to Hot Plug Detect */ reg = HOTPLUG_CHG | HPD_LOST | PLUG; writel(reg, &dp_regs->common_int_sta4); @@ -366,7 +366,7 @@ void exynos_dp_init_aux(void) { unsigned int reg; - /* Clear inerrupts related to AUX channel */ + /* Clear interrupts related to AUX channel */ reg = RPLY_RECEIV | AUX_ERR; writel(reg, &dp_regs->int_sta); @@ -377,7 +377,7 @@ void exynos_dp_init_aux(void) AUX_HW_RETRY_INTERVAL_600_MICROSECONDS; writel(reg, &dp_regs->aux_hw_retry_ctl); - /* Receive AUX Channel DEFER commands equal to DEFFER_COUNT*64 */ + /* Receive AUX Channel DEFER commands equal to DEFER_COUNT*64 */ reg = DEFER_CTRL_EN | DEFER_COUNT(1); writel(reg, &dp_regs->aux_ch_defer_ctl); @@ -1040,7 +1040,7 @@ void exynos_dp_config_video_slave_mode(struct edp_video_info *video_info) reg |= (video_info->h_sync_polarity << H_S_POLARITY_CFG_SHIFT); writel(reg, &dp_regs->video_ctl10); - /*Set video mode to slave mode */ + /* Set video mode to slave mode */ reg = AUDIO_MODE_SPDIF_MODE | VIDEO_MODE_SLAVE_MODE; writel(reg, &dp_regs->soc_general_ctl); }