From: Hans de Goede Date: Tue, 22 Mar 2016 19:10:30 +0000 (+0100) Subject: sunxi: Turn satapwr on from board_init X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=9fbb0c3aa49f4604b0342cb527a6bd099f92eaeb;p=u-boot.git sunxi: Turn satapwr on from board_init There are 2 reasons for doing this: 1) The main reason for doing this is to move it outside of board/sunxi/ahci.c, so that it can be used on boards which use a usb<->sata chip too; 2) While doing this I realized that doing it from board_init also meant doing it much earlier. Some printf get_timer(0) calls show that the time between board_init() and scsi_init() is more then 600 ms, so we can drop the mdelay(500) While at it also drop the printf("SUNXI SCSI INIT\n") AHCI init is noisy enough by itself. Signed-off-by: Hans de Goede Acked-by: Ian Campbell --- diff --git a/board/sunxi/ahci.c b/board/sunxi/ahci.c index 6d51b9b8e9..522e54ab16 100644 --- a/board/sunxi/ahci.c +++ b/board/sunxi/ahci.c @@ -72,14 +72,6 @@ static int sunxi_ahci_phy_init(u32 base) void scsi_init(void) { - printf("SUNXI SCSI INIT\n"); -#ifdef CONFIG_SATAPWR - gpio_request(CONFIG_SATAPWR, "satapwr"); - gpio_direction_output(CONFIG_SATAPWR, 1); - /* Give attached sata device time to power-up to avoid link timeouts */ - mdelay(500); -#endif - if (sunxi_ahci_phy_init(SUNXI_SATA_BASE) < 0) return; diff --git a/board/sunxi/board.c b/board/sunxi/board.c index e16718f308..2e2a1f59bc 100644 --- a/board/sunxi/board.c +++ b/board/sunxi/board.c @@ -90,6 +90,10 @@ int board_init(void) if (ret) return ret; +#ifdef CONFIG_SATAPWR + gpio_request(CONFIG_SATAPWR, "satapwr"); + gpio_direction_output(CONFIG_SATAPWR, 1); +#endif #ifdef CONFIG_MACPWR gpio_request(CONFIG_MACPWR, "macpwr"); gpio_direction_output(CONFIG_MACPWR, 1);