From: Tim Harvey Date: Tue, 27 Jul 2021 22:19:34 +0000 (-0700) Subject: arm: dts: imx8mm-venice-gw71xx: fix USB OTG VBUS X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=98559e02f16fc3fb96b0760d1b63780c46d95eab;p=u-boot.git arm: dts: imx8mm-venice-gw71xx: fix USB OTG VBUS The GW71xx has a USB Type-C connector with USB 2.0 signaling. GPIO1_12 is the power-enable to the TPS25821 Source controller and power switch responsible for monitoring the CC pins and enabling VBUS. Therefore GPIO1_12 must always be enabled and the vbus output enable from the IMX8MM can be ignored. To fix USB OTG VBUS enable a pull-up on GPIO1_12 to always power the TPS25821 and change the regulator output to GPIO1_10 which is unconnected. Signed-off-by: Tim Harvey --- diff --git a/arch/arm/dts/imx8mm-venice-gw71xx.dtsi b/arch/arm/dts/imx8mm-venice-gw71xx.dtsi index 905b68a3da..8e4a0ce997 100644 --- a/arch/arm/dts/imx8mm-venice-gw71xx.dtsi +++ b/arch/arm/dts/imx8mm-venice-gw71xx.dtsi @@ -46,7 +46,7 @@ pinctrl-0 = <&pinctrl_reg_usb1_en>; compatible = "regulator-fixed"; regulator-name = "usb_otg1_vbus"; - gpio = <&gpio1 12 GPIO_ACTIVE_HIGH>; + gpio = <&gpio1 10 GPIO_ACTIVE_HIGH>; enable-active-high; regulator-min-microvolt = <5000000>; regulator-max-microvolt = <5000000>; @@ -156,7 +156,8 @@ pinctrl_reg_usb1_en: regusb1grp { fsl,pins = < - MX8MM_IOMUXC_GPIO1_IO12_GPIO1_IO12 0x41 + MX8MM_IOMUXC_GPIO1_IO10_GPIO1_IO10 0x41 + MX8MM_IOMUXC_GPIO1_IO12_GPIO1_IO12 0x141 MX8MM_IOMUXC_GPIO1_IO13_USB1_OTG_OC 0x41 >; };