From: Anton Vorontsov Date: Thu, 19 Feb 2009 15:20:39 +0000 (+0300) Subject: mpc83xx: MPC837XEMDS: Initialize SerDes before negating PCIE reset signal X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=7e2ec1de1d2d723b59d7dd2fb85ff71b952d63af;p=u-boot.git mpc83xx: MPC837XEMDS: Initialize SerDes before negating PCIE reset signal The SerDes initialization should be finished before negating the reset signal according to the reference manual. This isn't an issue on real hardware, but we'd better stick to the specifications anyway. Suggested-by: Liu Dave Signed-off-by: Anton Vorontsov Signed-off-by: Kim Phillips --- diff --git a/board/freescale/mpc837xemds/pci.c b/board/freescale/mpc837xemds/pci.c index 31116b31ce..29de2e77f0 100644 --- a/board/freescale/mpc837xemds/pci.c +++ b/board/freescale/mpc837xemds/pci.c @@ -115,6 +115,13 @@ skip_pci: if (PARTID_NO_E(spridr) == SPR_8379) return; + if (pex2) + fsl_setup_serdes(CONFIG_FSL_SERDES2, FSL_SERDES_PROTO_PEX_X2, + FSL_SERDES_CLK_100, FSL_SERDES_VDD_1V); + else + fsl_setup_serdes(CONFIG_FSL_SERDES2, FSL_SERDES_PROTO_PEX, + FSL_SERDES_CLK_100, FSL_SERDES_VDD_1V); + /* Configure the clock for PCIE controller */ clrsetbits_be32(&clk->sccr, SCCR_PCIEXP1CM | SCCR_PCIEXP2CM, SCCR_PCIEXP1CM_1 | SCCR_PCIEXP2CM_1); @@ -132,13 +139,6 @@ skip_pci: out_be32(&pcie_law[1].bar, CONFIG_SYS_PCIE2_BASE & LAWBAR_BAR); out_be32(&pcie_law[1].ar, LBLAWAR_EN | LBLAWAR_512MB); - if (pex2) - fsl_setup_serdes(CONFIG_FSL_SERDES2, FSL_SERDES_PROTO_PEX_X2, - FSL_SERDES_CLK_100, FSL_SERDES_VDD_1V); - else - fsl_setup_serdes(CONFIG_FSL_SERDES2, FSL_SERDES_PROTO_PEX, - FSL_SERDES_CLK_100, FSL_SERDES_VDD_1V); - mpc83xx_pcie_init(pex2 ? 1 : 2, pcie_reg, 0); }