From: Simon Glass Date: Sat, 30 Jan 2016 23:37:45 +0000 (-0700) Subject: tegra: gpio: Show the GPIO value for outputs X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=651827c0fc3d91e0a6f2170890a11bc77557ee2e;p=u-boot.git tegra: gpio: Show the GPIO value for outputs The tegra GPIO controller has two ways of reading the value of a GPIO. It can supply the 'input' value (which is the value read from the pin) and the 'output' value (which is the value being driven from the pin. With a GPIO set to output mode, the 'input' value is always low which is not very useful. This has the unfortunate result that setting a GPIO high still leaves it showing as low in the 'gpio status' command. Adjust the driver to check which direction the GPIO is set to, then read the value from the appropriate register: 'input' for input GPIOs, 'output' for output GPIOs. Signed-off-by: Simon Glass Reviewed-by: Joe Hershberger Signed-off-by: Tom Warren --- diff --git a/drivers/gpio/tegra_gpio.c b/drivers/gpio/tegra_gpio.c index 8e880e276f..5a031159ca 100644 --- a/drivers/gpio/tegra_gpio.c +++ b/drivers/gpio/tegra_gpio.c @@ -177,7 +177,10 @@ static int tegra_gpio_get_value(struct udevice *dev, unsigned offset) debug("%s: pin = %d (port %d:bit %d)\n", __func__, gpio, GPIO_FULLPORT(gpio), GPIO_BIT(gpio)); - val = readl(&state->bank->gpio_in[GPIO_PORT(gpio)]); + if (get_direction(gpio) == DIRECTION_INPUT) + val = readl(&state->bank->gpio_in[GPIO_PORT(gpio)]); + else + val = readl(&state->bank->gpio_out[GPIO_PORT(gpio)]); return (val >> GPIO_BIT(gpio)) & 1; }