From: Pali Rohár Date: Sun, 7 Feb 2021 13:50:12 +0000 (+0100) Subject: arm: omap3: Compile lowlevel_init() function only when it is used X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=628680a99f21f6f60415d9e6d0e4b6adfb873c62;p=u-boot.git arm: omap3: Compile lowlevel_init() function only when it is used Function lowlevel_init() is called only from cpu_init_crit() and this function is wrapped into #if .. #endif section. So compile also lowlevel_init() function under same #if condition. Function cpy_clk_code() uses lowlevel_init symbol to get address where go_to_speed code ends. As this symbol is not available anymore when compiling with CONFIG_SKIP_LOWLEVEL_INIT, defines a new label go_to_speed_end at the place where go_to_speed code ends. Signed-off-by: Pali Rohár Reviewed-by: Lukasz Majewski Acked-by: Pavel Machek --- diff --git a/arch/arm/mach-omap2/omap3/lowlevel_init.S b/arch/arm/mach-omap2/omap3/lowlevel_init.S index 2a05b5e521..4fa89418a1 100644 --- a/arch/arm/mach-omap2/omap3/lowlevel_init.S +++ b/arch/arm/mach-omap2/omap3/lowlevel_init.S @@ -45,7 +45,7 @@ ENDPROC(do_omap3_emu_romcode_call) ENTRY(cpy_clk_code) /* Copy DPLL code into SRAM */ adr r0, go_to_speed /* copy from start of go_to_speed... */ - adr r2, lowlevel_init /* ... up to start of low_level_init */ + adr r2, go_to_speed_end /* ... up to start of go_to_speed_end */ next2: ldmia r0!, {r3 - r10} /* copy from source address [r0] */ stmia r1!, {r3 - r10} /* copy to target address [r1] */ @@ -167,8 +167,11 @@ pll_div_add5: pll_div_val5: .word CLSEL1_EMU_VAL +go_to_speed_end: #endif +#if !defined(CONFIG_SKIP_LOWLEVEL_INIT) && \ + !defined(CONFIG_SKIP_LOWLEVEL_INIT_ONLY) ENTRY(lowlevel_init) ldr sp, SRAM_STACK str ip, [sp] /* stash ip register */ @@ -187,6 +190,7 @@ ENTRY(lowlevel_init) b s_init ENDPROC(lowlevel_init) +#endif /* the literal pools origin */ .ltorg