From: Masahiro Yamada Date: Tue, 21 Jul 2015 05:04:24 +0000 (+0900) Subject: ARM: UniPhier: document reference support card X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=62102bee1ff32e7eda8b31558b0b646df74fecfd;p=u-boot.git ARM: UniPhier: document reference support card Signed-off-by: Masahiro Yamada --- diff --git a/doc/README.uniphier b/doc/README.uniphier index 4dacc9c413..52d681b57a 100644 --- a/doc/README.uniphier +++ b/doc/README.uniphier @@ -85,6 +85,48 @@ Supported devices - Support card (SRAM, NOR flash, some peripherals) +Micro Support Card +------------------ + +The recommended bit switch settings are as follows: + + SW2 OFF(1)/ON(0) Description + ------------------------------------------ + bit 1 <---- BKSZ[0] + bit 2 ----> BKSZ[1] + bit 3 <---- SoC Bus Width 16/32 + bit 4 <---- SERIAL_SEL[0] + bit 5 ----> SERIAL_SEL[1] + bit 6 ----> BOOTSWAP_EN + bit 7 <---- CS1/CS5 + bit 8 <---- SOC_SERIAL_DISABLE + + SW8 OFF(1)/ON(0) Description + ------------------------------------------ + bit 1 ----> CS1_SPLIT + bit 2 <---- CASE9_ON + bit 3 <---- CASE10_ON + bit 4 Don't Care Reserve + bit 5 Don't Care Reserve + bit 6 Don't Care Reserve + bit 7 ----> BURST_EN + bit 8 ----> FLASHBUS32_16 + +The BKSZ[1:0] specifies the address range of memory slot and peripherals +as follows: + + BKSZ Description RAM slot Peripherals + -------------------------------------------------------------------- + 0b00 15MB RAM / 1MB Peri 00000000-0effffff 0f000000-0fffffff + 0b01 31MB RAM / 1MB Peri 00000000-1effffff 1f000000-1fffffff + 0b10 64MB RAM / 1MB Peri 00000000-3effffff 3f000000-3fffffff + 0b11 127MB RAM / 1MB Peri 00000000-7effffff 7f000000-7fffffff + +Set BSKZ[1:0] to 0b01 for U-Boot. +This mode is the most handy because EA[24] is always supported by the save pin +mode of the system bus. On the other hand, EA[25] is not supported for some +newer SoCs. Even if it is, EA[25] is not connected on most of the boards. + -- -Masahiro Yamada -Feb. 2015 +Masahiro Yamada +Jul. 2015