From: Fabio Estevam Date: Wed, 13 Dec 2023 12:16:12 +0000 (-0300) Subject: imx8qm_dmsse20a1: Improve SPL memory configuration X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=595b8be3afe54520432e1f8be8e01e3610228d42;p=u-boot.git imx8qm_dmsse20a1: Improve SPL memory configuration Currently, building imx8qm_dmsse20a1_defconfig leads to the following warning: aarch64-linux-ld.bfd: invalid origin for memory region .sdram Fix it by using the same SPL memory layout as done in the imx8mq_evk. Reported-by: Tom Rini Signed-off-by: Fabio Estevam Tested-by: Oliver Graute --- diff --git a/configs/imx8qm_dmsse20a1_defconfig b/configs/imx8qm_dmsse20a1_defconfig index 01eabc43fb..017a541913 100644 --- a/configs/imx8qm_dmsse20a1_defconfig +++ b/configs/imx8qm_dmsse20a1_defconfig @@ -20,6 +20,7 @@ CONFIG_TARGET_IMX8QM_DMSSE20_A1=y CONFIG_SPL_MMC=y CONFIG_SPL_SERIAL=y CONFIG_SPL_DRIVERS_MISC=y +CONFIG_SPL_STACK=0x13e000 CONFIG_SPL=y CONFIG_SYS_LOAD_ADDR=0x80280000 CONFIG_REMAKE_ELF=y @@ -32,8 +33,16 @@ CONFIG_USE_BOOTCOMMAND=y CONFIG_BOOTCOMMAND="mmc dev ${mmcdev}; if mmc rescan; then if run loadbootscript; then run bootscript; else if run loadimage; then run mmcboot; else run netboot; fi; fi; else booti ${loadaddr} - ${fdt_addr}; fi" CONFIG_LOG=y # CONFIG_DISPLAY_CPUINFO is not set +CONFIG_SPL_SYS_MALLOC_SIMPLE=y +# CONFIG_SPL_SHARES_INIT_SP_ADDR is not set +CONFIG_SPL_SYS_MALLOC=y +CONFIG_SPL_HAS_CUSTOM_MALLOC_START=y +CONFIG_SPL_CUSTOM_SYS_MALLOC_ADDR=0x120000 +CONFIG_SPL_SYS_MALLOC_SIZE=0x3000 CONFIG_BOARD_EARLY_INIT_F=y CONFIG_SPL_MAX_SIZE=0x1f000 +CONFIG_SPL_HAS_BSS_LINKER_SECTION=y +CONFIG_SPL_BSS_START_ADDR=0x128000 CONFIG_SPL_BSS_MAX_SIZE=0x1000 CONFIG_SPL_BOARD_INIT=y CONFIG_SPL_POWER_DOMAIN=y