From: Wolfgang Denk Date: Tue, 21 Mar 2006 00:58:07 +0000 (+0100) Subject: Cleanup MCC200 board configuration; omit non-existent stuff. X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=5725f94aace1ed75bbeb9f3c528f34d1ae4dbe69;p=u-boot.git Cleanup MCC200 board configuration; omit non-existent stuff. --- diff --git a/CHANGELOG b/CHANGELOG index 08595d52e0..f96f3f9f22 100644 --- a/CHANGELOG +++ b/CHANGELOG @@ -2,6 +2,8 @@ Changes since U-Boot 1.1.4: ====================================================================== +* Cleanup MCC200 board configuration; omit non-existent stuff. + * Add support for MPC859/866 Rev. A.0 * Add command for handling DDR ECC registers on MPC8349EE MDS board. diff --git a/include/configs/mcc200.h b/include/configs/mcc200.h index d4dee3b77a..b9b54eb879 100644 --- a/include/configs/mcc200.h +++ b/include/configs/mcc200.h @@ -67,13 +67,8 @@ #define CONFIG_COMMANDS (CONFIG_CMD_DFL | \ ADD_USB_CMD | \ CFG_CMD_BEDBUG | \ - CFG_CMD_DATE | \ - CFG_CMD_DHCP | \ - CFG_CMD_EEPROM | \ CFG_CMD_FAT | \ - CFG_CMD_I2C | \ - CFG_CMD_NFS | \ - CFG_CMD_SNTP ) + CFG_CMD_I2C) /* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */ #include @@ -131,25 +126,11 @@ * I2C configuration */ #define CONFIG_HARD_I2C 1 /* I2C with hardware support */ -#define CFG_I2C_MODULE 2 /* Select I2C module #1 or #2 */ +#define CFG_I2C_MODULE 1 /* Select I2C module #1 or #2 */ #define CFG_I2C_SPEED 100000 /* 100 kHz */ #define CFG_I2C_SLAVE 0x7F -/* - * EEPROM configuration - */ -#define CFG_I2C_EEPROM_ADDR 0x58 -#define CFG_I2C_EEPROM_ADDR_LEN 1 -#define CFG_EEPROM_PAGE_WRITE_BITS 4 -#define CFG_EEPROM_PAGE_WRITE_DELAY_MS 10 - -/* - * RTC configuration - */ -#define CONFIG_RTC_PCF8563 -#define CFG_I2C_RTC_ADDR 0x51 - /* * Flash configuration (8,16 or 32 MB) * TEXT base always at 0xFFF00000 @@ -231,7 +212,7 @@ */ /* 0x10000004 = 32MB SDRAM */ /* 0x90000004 = 64MB SDRAM */ -#define CFG_GPS_PORT_CONFIG 0x10000004 +#define CFG_GPS_PORT_CONFIG 0x00000004 /* * Miscellaneous configurable options