From: Tom Rini Date: Mon, 20 Jun 2022 14:31:28 +0000 (-0400) Subject: doc: environment: Expand on fdt_addr, initrd_addr and loadaddr X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=556af511d4731a4eaee3a6010528c3e115059ffa;p=u-boot.git doc: environment: Expand on fdt_addr, initrd_addr and loadaddr - Explain why fdt_addr and initrd_addr should not be set to disable relocation normally. - Provide some advice on the typical loadaddr default value. Signed-off-by: Tom Rini Reviewed-by: Simon Glass --- diff --git a/doc/usage/environment.rst b/doc/usage/environment.rst index a3f23d4e4e..83543f63f6 100644 --- a/doc/usage/environment.rst +++ b/doc/usage/environment.rst @@ -204,7 +204,9 @@ fdt_high to work it must reside in writable memory, have sufficient padding on the end of it for u-boot to add the information it needs into it, and the memory - must be accessible by the kernel. + must be accessible by the kernel. This usage is strongly discouraged + however as it also stops U-Boot from ensuring the device tree starting + address is properly aligned and a misaligned tree will cause OS failures. fdtcontroladdr if set this is the address of the control flattened @@ -240,14 +242,21 @@ initrd_high memory. In this case U-Boot will NOT COPY the ramdisk at all. This may be useful to reduce the boot time on your system, but requires that this - feature is supported by your Linux kernel. + feature is supported by your Linux kernel. This usage however requires + that the user ensure that there will be no overlap with other parts of the + image such as the Linux kernel BSS. It should not be enabled by default + and only done as part of optimizing a deployment. ipaddr IP address; needed for tftpboot command loadaddr Default load address for commands like "bootp", - "rarpboot", "tftpboot", "loadb" or "diskboot" + "rarpboot", "tftpboot", "loadb" or "diskboot". Note that the optimal + default values here will vary between architectures. On 32bit ARM for + example, some offset from start of memory is used as the Linux kernel + zImage has a self decompressor and it's best if we stay out of where that + will be working. loads_echo see CONFIG_LOADS_ECHO