From: Bob Feretich Date: Thu, 24 Feb 2011 13:16:44 +0000 (+0000) Subject: OMAP3 Beagle Pin Mux initialization glitch fix X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=52d82e40b0332119d14f206555863c77b4f5edb3;p=u-boot.git OMAP3 Beagle Pin Mux initialization glitch fix The below patch reverses the order of two segments in the board file. Output pins need to have their values initialized, before they are exposed to the logic outside the chip. Signed-off-by: Bob Feretich Cc: Wolfgang Denk Signed-off-by: Sandeep Paulraj --- diff --git a/board/ti/beagle/beagle.c b/board/ti/beagle/beagle.c index ab50514f25..15d061a008 100644 --- a/board/ti/beagle/beagle.c +++ b/board/ti/beagle/beagle.c @@ -301,17 +301,17 @@ int misc_init_r(void) twl4030_power_init(); twl4030_led_init(TWL4030_LED_LEDEN_LEDAON | TWL4030_LED_LEDEN_LEDBON); - /* Configure GPIOs to output */ - writel(~(GPIO23 | GPIO10 | GPIO8 | GPIO2 | GPIO1), &gpio6_base->oe); - writel(~(GPIO31 | GPIO30 | GPIO29 | GPIO28 | GPIO22 | GPIO21 | - GPIO15 | GPIO14 | GPIO13 | GPIO12), &gpio5_base->oe); - - /* Set GPIOs */ + /* Set GPIO states before they are made outputs */ writel(GPIO23 | GPIO10 | GPIO8 | GPIO2 | GPIO1, &gpio6_base->setdataout); writel(GPIO31 | GPIO30 | GPIO29 | GPIO28 | GPIO22 | GPIO21 | GPIO15 | GPIO14 | GPIO13 | GPIO12, &gpio5_base->setdataout); + /* Configure GPIOs to output */ + writel(~(GPIO23 | GPIO10 | GPIO8 | GPIO2 | GPIO1), &gpio6_base->oe); + writel(~(GPIO31 | GPIO30 | GPIO29 | GPIO28 | GPIO22 | GPIO21 | + GPIO15 | GPIO14 | GPIO13 | GPIO12), &gpio5_base->oe); + dieid_num_r(); return 0;