From: Neha Malcom Francis Date: Wed, 27 Sep 2023 13:09:52 +0000 (+0530) Subject: arm: mach-k3: j721e_init: Move clk_k3 probe before loading TIFS X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=50fa67d091b6ffbc1d77d3100d7b31795bf64928;p=u-boot.git arm: mach-k3: j721e_init: Move clk_k3 probe before loading TIFS When setting boot media to load the TIFS binary in legacy boot flow (followed by J721E), get_timer() is called which eventually calls dm_timer_init() to grab the tick-timer, which is mcu_timer0. Since we need to set up the clocks before using the timer, move clk_k3 driver probe before k3_sysfw_loader to ensure we have all necessary clocks set up before. Signed-off-by: Neha Malcom Francis Reviewed-by: Nishanth Menon Reviewed-by: Manorit Chawdhry --- diff --git a/arch/arm/mach-k3/j721e_init.c b/arch/arm/mach-k3/j721e_init.c index b6164575b7..b1f7e25ed0 100644 --- a/arch/arm/mach-k3/j721e_init.c +++ b/arch/arm/mach-k3/j721e_init.c @@ -228,6 +228,18 @@ void board_init_f(ulong dummy) if (!ret) pinctrl_select_state(dev, "default"); + /* + * Force probe of clk_k3 driver here to ensure basic default clock + * configuration is always done. + */ + if (IS_ENABLED(CONFIG_SPL_CLK_K3)) { + ret = uclass_get_device_by_driver(UCLASS_CLK, + DM_DRIVER_GET(ti_clk), + &dev); + if (ret) + panic("Failed to initialize clk-k3!\n"); + } + /* * Load, start up, and configure system controller firmware. Provide * the U-Boot console init function to the SYSFW post-PM configuration @@ -241,18 +253,6 @@ void board_init_f(ulong dummy) do_dt_magic(); #endif - /* - * Force probe of clk_k3 driver here to ensure basic default clock - * configuration is always done. - */ - if (IS_ENABLED(CONFIG_SPL_CLK_K3)) { - ret = uclass_get_device_by_driver(UCLASS_CLK, - DM_DRIVER_GET(ti_clk), - &dev); - if (ret) - panic("Failed to initialize clk-k3!\n"); - } - /* Prepare console output */ preloader_console_init();