From: Samuel Holland Date: Sun, 10 Apr 2022 05:13:33 +0000 (-0500) Subject: sunxi: Skip MMC0 init when its pinmux conflicts with UART0 X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=3ba0a25c444a0197662367131ca2533a4bccf16a;p=u-boot.git sunxi: Skip MMC0 init when its pinmux conflicts with UART0 Currently, selecting UART0_PORT_F entirely disables MMC support on sunxi platforms. But this is a bigger hammer then needed. Muxing UART0 to the pins on port F only causes a conflict with MMC0, so minimize the impact by specifically skipping MMC0 init. We can continue to use MMC1/2 if those are enabled. Let's also remove the preprocessor check while refacting this function. Signed-off-by: Samuel Holland Reviewed-by: Andre Przywara Signed-off-by: Andre Przywara --- diff --git a/board/sunxi/board.c b/board/sunxi/board.c index 371ed9eeba..806e3bcb69 100644 --- a/board/sunxi/board.c +++ b/board/sunxi/board.c @@ -516,19 +516,17 @@ static void mmc_pinmux_setup(int sdc) int board_mmc_init(struct bd_info *bis) { - __maybe_unused struct mmc *mmc0, *mmc1; - - mmc_pinmux_setup(CONFIG_MMC_SUNXI_SLOT); - mmc0 = sunxi_mmc_init(CONFIG_MMC_SUNXI_SLOT); - if (!mmc0) - return -1; + if (!IS_ENABLED(CONFIG_UART0_PORT_F)) { + mmc_pinmux_setup(CONFIG_MMC_SUNXI_SLOT); + if (!sunxi_mmc_init(CONFIG_MMC_SUNXI_SLOT)) + return -1; + } -#if CONFIG_MMC_SUNXI_SLOT_EXTRA != -1 - mmc_pinmux_setup(CONFIG_MMC_SUNXI_SLOT_EXTRA); - mmc1 = sunxi_mmc_init(CONFIG_MMC_SUNXI_SLOT_EXTRA); - if (!mmc1) - return -1; -#endif + if (CONFIG_MMC_SUNXI_SLOT_EXTRA != -1) { + mmc_pinmux_setup(CONFIG_MMC_SUNXI_SLOT_EXTRA); + if (!sunxi_mmc_init(CONFIG_MMC_SUNXI_SLOT_EXTRA)) + return -1; + } return 0; }