From: Christian Gmeiner Date: Mon, 10 Nov 2014 13:35:48 +0000 (+0100) Subject: ot1200: add support for EHCI X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=39c7d5a222c50b6bb0618aa07d9951e730e6ff4b;p=u-boot.git ot1200: add support for EHCI U-Boot 2014.10-17457-g0b23780-dirty (Nov 10 2014 - 11:41:04) CPU: Freescale i.MX6D rev1.2 at 792 MHz Reset cause: WDOG Board: ot1200 I2C: ready DRAM: 1 GiB MMC: FSL_SDHC: 0, FSL_SDHC: 1 SF: Detected M25P16 with page size 256 Bytes, erase size 64 KiB, total 2 MiB In: serial Out: serial Err: serial Net: using phy at 0 FEC [PRIME] Hit any key to stop autoboot: 0 => usb start (Re)start USB... USB0: Port not available. USB1: USB EHCI 1.00 scanning bus 1 for devices... 4 USB Device(s) found => usb tree USB device tree: 1 Hub (480 Mb/s, 0mA) | u-boot EHCI Host Controller | +-2 Hub (480 Mb/s, 2mA) | +-3 Mass Storage (480 Mb/s, 80mA) | USBest Technology USB Mass Storage Device 0000000000028B | +-4 Vendor specific (480 Mb/s, 2mA) => Signed-off-by: Christian Gmeiner --- diff --git a/include/configs/ot1200.h b/include/configs/ot1200.h index d7696bd203..9512b1e150 100644 --- a/include/configs/ot1200.h +++ b/include/configs/ot1200.h @@ -83,6 +83,13 @@ #define CONFIG_GENERIC_MMC #define CONFIG_BOUNCE_BUFFER +/* USB Configs */ +#define CONFIG_CMD_USB +#define CONFIG_USB_EHCI +#define CONFIG_USB_EHCI_MX6 +#define CONFIG_MXC_USB_PORTSC (PORT_PTS_UTMI | PORT_PTS_PTW) +#define CONFIG_USB_MAX_CONTROLLER_COUNT 2 + #ifdef CONFIG_MX6Q #define CONFIG_CMD_SATA #endif