From: Peter Robinson Date: Wed, 22 Nov 2023 22:57:07 +0000 (+0000) Subject: doc: Remove README.sha1 file X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=38003ab25cc5a23335f55977620dc28ac7ca7657;p=u-boot.git doc: Remove README.sha1 file The contents of README.sha1 only refer to process around verification of the pcs440ep board firmware in flash. The device was removed in commit 242836a893ae ("powerpc: ppc4xx: remove pcs440ep support") in 2015 so this readme isn't really relevant anymore so can be removed. Signed-off-by: Peter Robinson Reviewed-by: Simon Glass --- diff --git a/doc/README.sha1 b/doc/README.sha1 deleted file mode 100644 index f178f37264..0000000000 --- a/doc/README.sha1 +++ /dev/null @@ -1,58 +0,0 @@ -SHA1 usage: ------------ - -In the U-Boot Image for the pcs440ep board is a SHA1 checksum integrated. -This SHA1 sum is used, to check, if the U-Boot Image in Flash is not -corrupted. - -The following command is available: - -=> help sha1 -sha1 address len [addr] calculate the SHA1 sum [save at addr] - -p calculate the SHA1 sum from the U-Boot image in flash and print - -c check the U-Boot image in flash - -"sha1 -p" - calculates and prints the SHA1 sum, from the Image stored in Flash - -"sha1 -c" - check, if the SHA1 sum from the Image stored in Flash is correct - - -It is possible to calculate a SHA1 checksum from a memoryrange with: - -"sha1 address len" - -If you want to store a new Image in Flash for the pcs440ep board, -which has no SHA1 sum, you can do the following: - -a) cp the new Image on a position in RAM (here 0x300000) - (for this example we use the Image from Flash, stored at 0xfffa0000 and - 0x60000 Bytes long) - -"cp.b fffa0000 300000 60000" - -b) Initialize the SHA1 sum in the Image with 0x00 - The SHA1 sum is stored in Flash at: - CONFIG_SYS_MONITOR_BASE + CONFIG_SYS_MONITOR_LEN + SHA1_SUM_POS - for the pcs440ep Flash: 0xfffa0000 + 0x60000 + -0x20 - = 0xffffffe0 - for the example in RAM: 0x300000 + 0x60000 + -0x20 - = 0x35ffe0 - - note: a SHA1 checksum is 20 bytes long. - -"mw.b 35ffe0 0 14" - -c) now calculate the SHA1 sum from the memoryrange and write - the calculated checksum at the right place: - -"sha1 300000 60000 35ffe0" - -Now you have a U-Boot-Image for the pcs440ep board with the correct SHA1 sum. - -If you do a "buildman -k pcs440ep" or a "make all" to get the U-Boot image, -which will be found in ../current/ipam390/ - the correct SHA1 sum will be -automagically included in the U-Boot image. - -Heiko Schocher, 11 Jul 2007