From: Thinh Nguyen Date: Fri, 12 Apr 2024 20:26:06 +0000 (+0200) Subject: usb: dwc3: gadget: Disable GUSB2PHYCFG.SUSPHY for End Transfer X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=30f39de786ff3a87006461903e41a48c811ee764;p=u-boot.git usb: dwc3: gadget: Disable GUSB2PHYCFG.SUSPHY for End Transfer Upstream Linux commit 3aa07f72894d. If there's a disconnection while operating in eSS, there may be a delay in VBUS drop response from the connector. In that case, the internal link state may drop to operate in usb2 speed while the controller thinks the VBUS is still high. The driver must make sure to disable GUSB2PHYCFG.SUSPHY when sending endpoint command while in usb2 speed. The End Transfer command may be called, and only that command needs to go through at this point. Let's keep it simple and unconditionally disable GUSB2PHYCFG.SUSPHY whenever we issue the command. This scenario is not seen in real hardware. In a rare case, our prototype type-c controller/interface may have a slow response triggerring this issue. Signed-off-by: Thinh Nguyen Link: https://lore.kernel.org/r/5651117207803c26e2f22ddf4e5ce9e865dcf7c7.1668045468.git.Thinh.Nguyen@synopsys.com Signed-off-by: Greg Kroah-Hartman Signed-off-by: Alexander Sverdlin Reviewed-by: Mattijs Korpershoek Link: https://lore.kernel.org/r/20240412202611.3565052-7-alexander.sverdlin@siemens.com Signed-off-by: Mattijs Korpershoek --- diff --git a/drivers/usb/dwc3/gadget.c b/drivers/usb/dwc3/gadget.c index e8e8f82c05..fab3257564 100644 --- a/drivers/usb/dwc3/gadget.c +++ b/drivers/usb/dwc3/gadget.c @@ -315,7 +315,8 @@ int dwc3_send_gadget_ep_cmd(struct dwc3 *dwc, unsigned ep, * * DWC_usb3 3.30a and DWC_usb31 1.90a programming guide section 3.2.2 */ - if (dwc->gadget.speed <= USB_SPEED_HIGH) { + if (dwc->gadget.speed <= USB_SPEED_HIGH || + DWC3_DEPCMD_CMD(cmd) == DWC3_DEPCMD_ENDTRANSFER) { reg = dwc3_readl(dwc->regs, DWC3_GUSB2PHYCFG(0)); if (unlikely(reg & DWC3_GUSB2PHYCFG_SUSPHY)) { saved_config |= DWC3_GUSB2PHYCFG_SUSPHY;