From: Priyanka Jain Date: Tue, 8 Apr 2014 05:25:49 +0000 (+0530) Subject: driver/net/fm/memac_phy: Initialize mdio_clock for SoCs wih FMANv3 X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=2ee6c52e229e1d0d1e78c3efbc67bc8bb868fb25;p=u-boot.git driver/net/fm/memac_phy: Initialize mdio_clock for SoCs wih FMANv3 MDIO clock needs to be initialized in u-boot code for SoCs having FMAN-v3(v3H or v3L) controller due to below reasons -On SoCs that have FMAN-v3H like B4860, default value of MDIO_CLK_DIV bits in mdio_stat(mdio_cfg) register generates mdio clock too high (much higher than 2.5MHz), violating the IEEE specs. -On SOCs that have FMAN-v3L like T1040, default value of MDIO_CLK_DIV bits is zero, so MDIO clock is disabled. So, for proper functioninig of MDIO, MDIO_CLK_DIV bits needs to be properly initialized. Also this type of initialization is generally done in PBI(pre-bootloader) phase using rcw.But for chips like T1040 which support deep-sleep, such type of initialization cannot be done in PBI phase due to the limitation that during deep-sleep resume, FMAN (MDIO) registers are not accessible in PBI phase. So, mdio clock initailization must be done as part of u-boot. This initialization code is implemented in memac_phy.c which gets compiled only for SoCs having FMANv3, so no extra compilation flag is required. Signed-off-by: Priyanka Jain Reviewed-by: York Sun --- diff --git a/drivers/net/fm/memac_phy.c b/drivers/net/fm/memac_phy.c index 140e59b75c..2f4bc11a6c 100644 --- a/drivers/net/fm/memac_phy.c +++ b/drivers/net/fm/memac_phy.c @@ -133,5 +133,17 @@ int fm_memac_mdio_init(bd_t *bis, struct memac_mdio_info *info) bus->priv = info->regs; + /* + * On some platforms like B4860, default value of MDIO_CLK_DIV bits + * in mdio_stat(mdio_cfg) register generates MDIO clock too high + * (much higher than 2.5MHz), violating the IEEE specs. + * On other platforms like T1040, default value of MDIO_CLK_DIV bits + * is zero, so MDIO clock is disabled. + * So, for proper functioning of MDIO, MDIO_CLK_DIV bits needs to + * be properly initialized. + */ + setbits_be32(&((struct memac_mdio_controller *)info->regs)->mdio_stat, + MDIO_STAT_CLKDIV(258)); + return mdio_register(bus); }