From: Eugen Hristev <eugen.hristev@microchip.com>
Date: Fri, 3 May 2019 13:24:21 +0000 (+0300)
Subject: board: atmel: sama5d2_icp: standby disable on CAN transceivers in SPL
X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=2950c514e8fc2c9d6a48cd7187521bc648dc679e;p=u-boot.git

board: atmel: sama5d2_icp: standby disable on CAN transceivers in SPL

The 2 CAN transceivers have a STBDY pin which must be low in order to
operate.
This pin is tied to PB25.
Set it to 0 in bootstrap.
At a later time, this needs to be controlled by Linux power management
system, or requested by some driver as a gpio and tied to 0 during
CAN link up.

Signed-off-by: Eugen Hristev <eugen.hristev@microchip.com>
---

diff --git a/board/atmel/sama5d2_icp/sama5d2_icp.c b/board/atmel/sama5d2_icp/sama5d2_icp.c
index 1c28aaba85..f55ea2c6f8 100644
--- a/board/atmel/sama5d2_icp/sama5d2_icp.c
+++ b/board/atmel/sama5d2_icp/sama5d2_icp.c
@@ -73,6 +73,12 @@ int misc_init_r(void)
 /* SPL */
 #ifdef CONFIG_SPL_BUILD
 
+/* must set PB25 low to enable the CAN transceivers */
+static void board_can_stdby_dis(void)
+{
+	atmel_pio4_set_pio_output(AT91_PIO_PORTB, 25, 0);
+}
+
 /* deassert reset lines for external periph in case of warm reboot */
 static void board_reset_additional_periph(void)
 {
@@ -111,6 +117,7 @@ void spl_board_init(void)
 	spl_mmc_init();
 #endif
 	board_reset_additional_periph();
+	board_can_stdby_dis();
 }
 
 void spl_display_print(void)