From: Tero Kristo Date: Fri, 11 Jun 2021 08:45:04 +0000 (+0300) Subject: remoteproc: k3-r5: remove sysfw PM calls if not supported X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=25805b6f0cf29cbb8db15ae2f0d4801c2f349985;p=u-boot.git remoteproc: k3-r5: remove sysfw PM calls if not supported With the sysfw rearch, sysfw PM calls are no longer available from SPL level. To properly support this, remove the is_on checks and the reset assertion from the R5 remoteproc driver as these are not supported. Attempting to access unavailable services will cause the device to hang. Signed-off-by: Tero Kristo Signed-off-by: Tero Kristo --- diff --git a/drivers/remoteproc/ti_k3_r5f_rproc.c b/drivers/remoteproc/ti_k3_r5f_rproc.c index 3c569a3b7b..6f3e12d915 100644 --- a/drivers/remoteproc/ti_k3_r5f_rproc.c +++ b/drivers/remoteproc/ti_k3_r5f_rproc.c @@ -804,19 +804,27 @@ static int k3_r5f_probe(struct udevice *dev) return ret; } - ret = core->tsp.sci->ops.dev_ops.is_on(core->tsp.sci, core->tsp.dev_id, - &r_state, &core->in_use); - if (ret) - return ret; + /* + * The PM functionality is not supported by the firmware during + * SPL execution with the separated DM firmware image. The following + * piece of code is not compiled in that case. + */ + if (!IS_ENABLED(CONFIG_K3_DM_FW)) { + ret = core->tsp.sci->ops.dev_ops.is_on(core->tsp.sci, + core->tsp.dev_id, + &r_state, &core->in_use); + if (ret) + return ret; - if (core->in_use) { - dev_info(dev, "Core %d is already in use. No rproc commands work\n", - core->tsp.proc_id); - return 0; - } + if (core->in_use) { + dev_info(dev, "Core %d is already in use. No rproc commands work\n", + core->tsp.proc_id); + return 0; + } - /* Make sure Local reset is asserted. Redundant? */ - reset_assert(&core->reset); + /* Make sure Local reset is asserted. Redundant? */ + reset_assert(&core->reset); + } ret = k3_r5f_rproc_configure(core); if (ret) {