From: Angelo Dureghello <angelo@sysam.it>
Date: Sat, 19 Jan 2019 09:40:38 +0000 (+0100)
Subject: drivers: esdhc: add support for ColdFire mcf5441x family
X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=1f15cb8f5b1b675426a7072d6c978e1c415c94c8;p=u-boot.git

drivers: esdhc: add support for ColdFire mcf5441x family

This patch has been tested on the mcf54415-based stmark2
board. The eSDHC driver works reliably using DMA mode.

Signed-off-by: Angelo Dureghello <angelo@sysam.it>
---

diff --git a/drivers/mmc/fsl_esdhc.c b/drivers/mmc/fsl_esdhc.c
index 84637313e0..b8171ba08b 100644
--- a/drivers/mmc/fsl_esdhc.c
+++ b/drivers/mmc/fsl_esdhc.c
@@ -384,6 +384,25 @@ static void check_and_invalidate_dcache_range
 	invalidate_dcache_range(start, end);
 }
 
+#ifdef CONFIG_MCF5441x
+/*
+ * Swaps 32-bit words to little-endian byte order.
+ */
+static inline void sd_swap_dma_buff(struct mmc_data *data)
+{
+	int i, size = data->blocksize >> 2;
+	u32 *buffer = (u32 *)data->dest;
+	u32 sw;
+
+	while (data->blocks--) {
+		for (i = 0; i < size; i++) {
+			sw = __sw32(*buffer);
+			*buffer++ = sw;
+		}
+	}
+}
+#endif
+
 /*
  * Sends a command out on the bus.  Takes the mmc pointer,
  * a command pointer, and an optional data pointer.
@@ -546,8 +565,12 @@ static int esdhc_send_cmd_common(struct fsl_esdhc_priv *priv, struct mmc *mmc,
 		 * cache-fill during the DMA operations such as the
 		 * speculative pre-fetching etc.
 		 */
-		if (data->flags & MMC_DATA_READ)
+		if (data->flags & MMC_DATA_READ) {
 			check_and_invalidate_dcache_range(cmd, data);
+#ifdef CONFIG_MCF5441x
+			sd_swap_dma_buff(data);
+#endif
+		}
 #endif
 	}
 
@@ -1029,8 +1052,12 @@ static int esdhc_init_common(struct fsl_esdhc_priv *priv, struct mmc *mmc)
 	/* Disable the BRR and BWR bits in IRQSTAT */
 	esdhc_clrbits32(&regs->irqstaten, IRQSTATEN_BRR | IRQSTATEN_BWR);
 
+#ifdef CONFIG_MCF5441x
+	esdhc_write32(&regs->proctl, PROCTL_INIT | PROCTL_D3CD);
+#else
 	/* Put the PROCTL reg back to the default */
 	esdhc_write32(&regs->proctl, PROCTL_INIT);
+#endif
 
 	/* Set timout to the maximum value */
 	esdhc_clrsetbits32(&regs->sysctl, SYSCTL_TIMEOUT_MASK, 14 << 16);
@@ -1138,6 +1165,11 @@ static int fsl_esdhc_init(struct fsl_esdhc_priv *priv,
 	if (ret)
 		return ret;
 
+#ifdef CONFIG_MCF5441x
+	/* ColdFire, using SDHC_DATA[3] for card detection */
+	esdhc_write32(&regs->proctl, PROCTL_INIT | PROCTL_D3CD);
+#endif
+
 #ifndef CONFIG_FSL_USDHC
 	esdhc_setbits32(&regs->sysctl, SYSCTL_PEREN | SYSCTL_HCKEN
 				| SYSCTL_IPGEN | SYSCTL_CKEN);
@@ -1162,6 +1194,15 @@ static int fsl_esdhc_init(struct fsl_esdhc_priv *priv,
 	voltage_caps = 0;
 	caps = esdhc_read32(&regs->hostcapblt);
 
+#ifdef CONFIG_MCF5441x
+	/*
+	 * MCF5441x RM declares in more points that sdhc clock speed must
+	 * never exceed 25 Mhz. From this, the HS bit needs to be disabled
+	 * from host capabilities.
+	 */
+	caps &= ~ESDHC_HOSTCAPBLT_HSS;
+#endif
+
 #ifdef CONFIG_SYS_FSL_ERRATUM_ESDHC135
 	caps = caps & ~(ESDHC_HOSTCAPBLT_SRS |
 			ESDHC_HOSTCAPBLT_VS18 | ESDHC_HOSTCAPBLT_VS30);
diff --git a/include/fsl_esdhc.h b/include/fsl_esdhc.h
index acd8dd06f8..8dbd5249a7 100644
--- a/include/fsl_esdhc.h
+++ b/include/fsl_esdhc.h
@@ -106,6 +106,7 @@
 #define PROCTL_INIT		0x00000020
 #define PROCTL_DTW_4		0x00000002
 #define PROCTL_DTW_8		0x00000004
+#define PROCTL_D3CD		0x00000008
 
 #define CMDARG			0x0002e008