From: Sean Anderson Date: Fri, 16 Oct 2020 22:57:44 +0000 (-0400) Subject: spi: dw: Convert calls to debug to dev_* X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=1b3dd491e6fc787f47a3ae91f6a58aeb97466140;p=u-boot.git spi: dw: Convert calls to debug to dev_* This allows different log levels to be enabled or disabled depending on the desired level of verbosity. In particular, it allows for general debug information to be printed while excluding more verbose logging which may interfere with timing. Signed-off-by: Sean Anderson Reviewed-by: Jagan Teki Reviewed-by: Jagan Teki --- diff --git a/drivers/spi/designware_spi.c b/drivers/spi/designware_spi.c index 74372171aa..b23655d4d9 100644 --- a/drivers/spi/designware_spi.c +++ b/drivers/spi/designware_spi.c @@ -9,6 +9,7 @@ * Copyright (c) 2009, Intel Corporation. */ +#define LOG_CATEGORY UCLASS_SPI #include #include #include @@ -139,7 +140,7 @@ static int request_gpio_cs(struct udevice *bus) return 0; if (ret < 0) { - printf("Error: %d: Can't get %s gpio!\n", ret, bus->name); + dev_err(bus, "Couldn't request gpio! (error %d)\n", ret); return ret; } @@ -148,7 +149,7 @@ static int request_gpio_cs(struct udevice *bus) GPIOD_IS_OUT | GPIOD_IS_OUT_ACTIVE); } - debug("%s: used external gpio for CS management\n", __func__); + dev_dbg(bus, "Using external gpio for CS management\n"); #endif return 0; } @@ -162,8 +163,7 @@ static int dw_spi_ofdata_to_platdata(struct udevice *bus) /* Use 500KHz as a suitable default */ plat->frequency = dev_read_u32_default(bus, "spi-max-frequency", 500000); - debug("%s: regs=%p max-frequency=%d\n", __func__, plat->regs, - plat->frequency); + dev_info(bus, "max-frequency=%d\n", plat->frequency); return request_gpio_cs(bus); } @@ -174,7 +174,7 @@ static inline void spi_enable_chip(struct dw_spi_priv *priv, int enable) } /* Restart the controller, disable all interrupts, clean rx fifo */ -static void spi_hw_init(struct dw_spi_priv *priv) +static void spi_hw_init(struct udevice *bus, struct dw_spi_priv *priv) { spi_enable_chip(priv, 0); dw_write(priv, DW_SPI_IMR, 0xff); @@ -196,7 +196,7 @@ static void spi_hw_init(struct dw_spi_priv *priv) priv->fifo_len = (fifo == 1) ? 0 : fifo; dw_write(priv, DW_SPI_TXFLTR, 0); } - debug("%s: fifo_len=%d\n", __func__, priv->fifo_len); + dev_dbg(bus, "fifo_len=%d\n", priv->fifo_len); } /* @@ -221,8 +221,7 @@ __weak int dw_spi_get_clk(struct udevice *bus, ulong *rate) if (!*rate) goto err_rate; - debug("%s: get spi controller clk via device tree: %lu Hz\n", - __func__, *rate); + dev_dbg(bus, "Got clock via device tree: %lu Hz\n", *rate); return 0; @@ -247,14 +246,16 @@ static int dw_spi_reset(struct udevice *bus) if (ret == -ENOENT || ret == -ENOTSUPP) return 0; - dev_warn(bus, "Can't get reset: %d\n", ret); + dev_warn(bus, "Couldn't find/assert reset device (error %d)\n", + ret); return ret; } ret = reset_deassert_bulk(&priv->resets); if (ret) { reset_release_bulk(&priv->resets); - dev_err(bus, "Failed to reset: %d\n", ret); + dev_err(bus, "Failed to de-assert reset for SPI (error %d)\n", + ret); return ret; } @@ -284,7 +285,7 @@ static int dw_spi_probe(struct udevice *bus) priv->tmode = 0; /* Tx & Rx */ /* Basic HW init */ - spi_hw_init(priv); + spi_hw_init(bus, priv); return 0; } @@ -333,7 +334,7 @@ static void dw_writer(struct dw_spi_priv *priv) txw = *(u16 *)(priv->tx); } dw_write(priv, DW_SPI_DR, txw); - debug("%s: tx=0x%02x\n", __func__, txw); + log_content("tx=0x%02x\n", txw); priv->tx += priv->bits_per_word >> 3; } } @@ -345,7 +346,7 @@ static void dw_reader(struct dw_spi_priv *priv) while (max--) { rxw = dw_read(priv, DW_SPI_DR); - debug("%s: rx=0x%02x\n", __func__, rxw); + log_content("rx=0x%02x\n", rxw); /* Care about rx if the transfer's original "rx" is not null */ if (priv->rx_end - priv->len) { @@ -400,7 +401,7 @@ static int dw_spi_xfer(struct udevice *dev, unsigned int bitlen, /* spi core configured to do 8 bit transfers */ if (bitlen % 8) { - debug("Non byte aligned SPI transfer.\n"); + dev_err(dev, "Non byte aligned SPI transfer.\n"); return -1; } @@ -427,7 +428,6 @@ static int dw_spi_xfer(struct udevice *dev, unsigned int bitlen, cr0 |= (priv->tmode << SPI_TMOD_OFFSET); priv->len = bitlen >> 3; - debug("%s: rx=%p tx=%p len=%d [bytes]\n", __func__, rx, tx, priv->len); priv->tx = (void *)tx; priv->tx_end = priv->tx + priv->len; @@ -437,7 +437,8 @@ static int dw_spi_xfer(struct udevice *dev, unsigned int bitlen, /* Disable controller before writing control registers */ spi_enable_chip(priv, 0); - debug("%s: cr0=%08x\n", __func__, cr0); + dev_dbg(dev, "cr0=%08x rx=%p tx=%p len=%d [bytes]\n", cr0, rx, tx, + priv->len); /* Reprogram cr0 only if changed */ if (dw_read(priv, DW_SPI_CTRL0) != cr0) dw_write(priv, DW_SPI_CTRL0, cr0); @@ -497,8 +498,7 @@ static int dw_spi_set_speed(struct udevice *bus, uint speed) spi_enable_chip(priv, 1); priv->freq = speed; - debug("%s: regs=%p speed=%d clk_div=%d\n", __func__, priv->regs, - priv->freq, clk_div); + dev_dbg(bus, "speed=%d clk_div=%d\n", priv->freq, clk_div); return 0; } @@ -513,7 +513,7 @@ static int dw_spi_set_mode(struct udevice *bus, uint mode) * real transfer function. */ priv->mode = mode; - debug("%s: regs=%p, mode=%d\n", __func__, priv->regs, priv->mode); + dev_dbg(bus, "mode=%d\n", priv->mode); return 0; }