From: Andre Przywara <andre.przywara@arm.com>
Date: Tue, 2 Jan 2024 15:02:51 +0000 (+0000)
Subject: sunxi: remove unneeded i2c_init_board() call for U-Boot proper
X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=1a6828d0c54da2267cfc2a8abe7c51226f1cb80f;p=u-boot.git

sunxi: remove unneeded i2c_init_board() call for U-Boot proper

The driver used for the Allwinner I2C IP is using proper DT and DM
enablement for a while: we enable the clock gate and de-assert the reset
line in the driver's probe() routine, and the pinmux setup is taken care
of by the DM framework.

This means the explicit call to the i2c_init_board() routine is not
needed for U-Boot proper. As the board_init() function in board.c is
only called for U-Boot proper, we can remove the call, something that
the comment there hinted at already.

Fix the comment for the board_init() function on the way: we were not
really doing board specific setup there. The fact that this function
is called from U-Boot proper only is probably more helpful for reasoning
about this code.

Signed-off-by: Andre Przywara <andre.przywara@arm.com>
---

diff --git a/board/sunxi/board.c b/board/sunxi/board.c
index 8c12c8dead..1313b01dce 100644
--- a/board/sunxi/board.c
+++ b/board/sunxi/board.c
@@ -186,7 +186,7 @@ enum env_location env_get_location(enum env_operation op, int prio)
 	return ENVL_UNKNOWN;
 }
 
-/* add board specific code here */
+/* called only from U-Boot proper */
 int board_init(void)
 {
 	__maybe_unused int id_pfr1, ret;
@@ -226,13 +226,6 @@ int board_init(void)
 	if (ret)
 		return ret;
 
-#if CONFIG_IS_ENABLED(DM_I2C)
-	/*
-	 * Temporary workaround for enabling I2C clocks until proper sunxi DM
-	 * clk, reset and pinctrl drivers land.
-	 */
-	i2c_init_board();
-#endif
 	eth_init_board();
 
 	return 0;