From: Christian Gmeiner Date: Wed, 11 Feb 2015 14:19:31 +0000 (+0100) Subject: cmd_eeprom: make it possible to define the used i2c bus X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=189d257b7ad9c6c9c84941be27de8e31a6e87e86;p=u-boot.git cmd_eeprom: make it possible to define the used i2c bus A SoC like the i.MX6 supports more then one i2c bus. In oder to be able to use the eeprom command add a new define to specify the i2c bus to use. If CONFIG_SYS_I2C_EEPROM_BUS is not defined there is no functional change, else a call to i2c_set_bus_num(..) is done before calling i2c_read(..) and i2c_write(..). Signed-off-by: Christian Gmeiner Acked-by: Stefano Babic --- diff --git a/README b/README index ba57dc5617..f38ab15b8b 100644 --- a/README +++ b/README @@ -4341,6 +4341,9 @@ to save the current settings. If defined, specified the chip address of the EEPROM device. The default address is zero. + - CONFIG_SYS_I2C_EEPROM_BUS: + If defined, specified the i2c bus of the EEPROM device. + - CONFIG_SYS_EEPROM_PAGE_WRITE_BITS: If defined, the number of bits used to address bytes in a single page in the EEPROM device. A 64 byte page, for example diff --git a/common/cmd_eeprom.c b/common/cmd_eeprom.c index 29f0f1f784..e9904cd698 100644 --- a/common/cmd_eeprom.c +++ b/common/cmd_eeprom.c @@ -161,6 +161,9 @@ int eeprom_read (unsigned dev_addr, unsigned offset, uchar *buffer, unsigned cnt #if defined(CONFIG_SPI) && !defined(CONFIG_ENV_EEPROM_IS_ON_I2C) spi_read (addr, alen, buffer, len); #else +#if defined(CONFIG_SYS_I2C_EEPROM_BUS) + i2c_set_bus_num(CONFIG_SYS_I2C_EEPROM_BUS); +#endif if (i2c_read(addr[0], offset, alen - 1, buffer, len)) rcode = 1; #endif @@ -338,6 +341,9 @@ int eeprom_write (unsigned dev_addr, unsigned offset, uchar *buffer, unsigned cn } /* Write is enabled ... now write eeprom value. */ +#endif +#if defined(CONFIG_SYS_I2C_EEPROM_BUS) + i2c_set_bus_num(CONFIG_SYS_I2C_EEPROM_BUS); #endif if (i2c_write(addr[0], offset, alen - 1, buffer, len)) rcode = 1;