From: Michal Simek Date: Fri, 14 Jan 2022 12:25:37 +0000 (+0100) Subject: firmware: zynqmp: Do not report error if node is already configured X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=11c07719d58d4627e21fc59f5ab58f85edd5c024;p=u-boot.git firmware: zynqmp: Do not report error if node is already configured Power domain driver sends PM fragment to PMUFW. It is sent for every node which is listed in DT. But some nodes could be already enabled but driver is not capable to find it out. That's why it blinly sents request for every listed IP. When PMUFW response by XST_PM_ALREADY_CONFIGURED error code there is no need to show any error message because node is already enabled. That's why cover this case with message when DEBUG is enabled. Signed-off-by: Michal Simek Link: https://lore.kernel.org/r/8c15ef0b68cf191f693d3d010f70ac24cfd8171f.1642163135.git.michal.simek@xilinx.com --- diff --git a/drivers/firmware/firmware-zynqmp.c b/drivers/firmware/firmware-zynqmp.c index 18a092c7b4..839203ec82 100644 --- a/drivers/firmware/firmware-zynqmp.c +++ b/drivers/firmware/firmware-zynqmp.c @@ -20,6 +20,7 @@ #define PMUFW_PAYLOAD_ARG_CNT 8 #define XST_PM_NO_ACCESS 2002L +#define XST_PM_ALREADY_CONFIGURED 2009L struct zynqmp_power { struct mbox_chan tx_chan; @@ -110,6 +111,11 @@ void zynqmp_pmufw_load_config_object(const void *cfg_obj, size_t size) return; } + if (err == XST_PM_ALREADY_CONFIGURED) { + debug("PMUFW Node is already configured\n"); + return; + } + if (err) printf("Cannot load PMUFW configuration object (%d)\n", err);